2011 jeep compass

Home / the12volt's Install Bay / Car Security and Convenience / 2011 jeep compass (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

russbm

Member - Posts: 46

Joined: December 17, 2007

Location: Kentucky, United States

Posted: May 04, 2011 at 10:02 PM / IP Logged

Hello

I am installing a Seat heater on both front seat of a 2011 Jeep Compass, was going to connect the 12v hot wire to the ign 12v power outlet but i notice it is a small wire and not a thick one, even the ign 12v at the ign switch is small wire. What is the proper way for a relay diagram for this.

Thanks.

Russell

Back to Top

blanx218

Silver - Posts: 654

Joined: September 23, 2008

Location: Pennsylvania, United States

Posted: May 04, 2011 at 11:48 PM / IP Logged

Pin 87 to +12V battery power.

Pin 85 to the ignition wire

Pin 86 to ground

Pin 30 to the power wire of the seat heaters

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

2011 jeep compass

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.