08 tundra air bag light

Home / the12volt's Install Bay / Car Security and Convenience / 08 tundra air bag light (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

ziggyb222

Silver - Posts: 593

This member has made a donation to the12volt.com. Click here for more info.

Joined: January 04, 2004

Location: Maine, United States

Posted: December 30, 2011 at 3:25 PM / IP Logged

Installed a 4103 Avital in a 08 Tundra with and xk05 bypass.. Connected 12v to thick black wire at fuse box.. dark green to starter light green ignition 1 black ignition 2 and gray for acc... all 22 guage wires from the switch.... In remote start I get a air bag light and a tire pressure monitor light.. on key take over those lights do not go out. you need to shut the truck down and restart with the key.. when starter with a key there is no lights at all.. Tried swapping ignition wires no luck.. Also had a problem getting the remote into program mode.. I would assume there is a messed up ign or acc wire.. ignition wires tested fine.. HELP I need to get this truck wrapped up.. Thanks in advance!!!

Back to Top

shortcircuit161

Silver - Posts: 556

Joined: August 29, 2010

Location: United States

Posted: December 30, 2011 at 3:33 PM / IP Logged

If you start it with the key and try to have the Avital take over and remove the key, do the lights also turn on? And you've tested all your ignition connections to ensure that the pink/white cable from the Avital was programmed correctly to 2nd Ignition?

Back to Top

shortcircuit161

Silver - Posts: 556

Joined: August 29, 2010

Location: United States

Posted: December 30, 2011 at 3:50 PM / IP Logged

Generally a dash light comes on (such as airbag, check engine, etc) if an ignition/2nd ignition wire isn't getting power when the starter is engaged to start the truck. Therefore, the test I suggested before may not light the airbag and tire pressure lights, because it was started with the key that did power both ignition wires upon starting it. Hope that makes sense.

Back to Top

ziggyb222

Silver - Posts: 593

Joined: January 04, 2004

Location: Maine, United States

Posted: December 30, 2011 at 4:55 PM / IP Logged

Thanks for your replies... I tripple checked everything and determined I had a cold soldered joint on the 2nd ignition wire... soldering to the small wires I did not get a good connection. Lesson learned and all is fine now.. Thanks again for your suggestions it prodded me to check things over again!!!!!

Back to Top

shortcircuit161

Silver - Posts: 556

Joined: August 29, 2010

Location: United States

Posted: December 30, 2011 at 5:12 PM / IP Logged

Glad everything worked out. Enjoy it!!

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

08 tundra air bag light

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.