01 gmc yukon xl

Need remote start and alarm wiring

12volts      red (40A)      +      ignition harness Starter      yellow      +      ignition harness Second Starter      N/A            Ignition      pink      +      ignition harness Second Ignition      white      +      ignition harness Notes: To avoid the check engine light from coming on and possible damage to the automatic transmission, the second ignition in this vehicle MUST be powered when adding a remote start system. Third Ignition      N/A            Accessory      orange      +      ignition harness Second Accessory      brown      +      ignition harness Keysense      lt. green      -      ignition key switch Power Lock      lt. blue      +      BCM, brown plug, pin A4 Notes: The BCM (Body Control Module) is under the driver dash. Power Unlock      white      +      BCM, brown plug, pin A3 Notes: The BCM (Body Control Module) is under the driver dash. On some models, to unlock the driver door only, use lt. green (-) at the BCM, lt. blue plug, pin A4. Lock Motor      gray      5 wire      driver kick, door harness Unlock Motor      tan      5 wire      driver kick, door harness Parking Lights+      brown      +      BCM, lt. blue plug, pin B6 Notes: The BCM (Body Control Module) is under the driver dash. Parking Lights-      white      -      BCM, lt. blue plug, pin A5 Notes: The BCM (Body Control Module) is under the driver dash. Hazards      same as turn signals            Turn Signal(L)      lt. blue      +      turn signal switch Turn Signal(R)      dk. blue      +      turn signal switch Reverse Light      lt. green      +      inside rear view mirror Door Trigger      tan      -      BCM, purple plug, pin B4 Notes: The BCM (Body Control Module) is under the driver dash. Dome Supervision      gray/black (dome lamp), dk. green (puddle lamp)      -      BCM, lt. blue plug, pins A3 and A8 Notes: The BCM (Body Control Module) is under the driver dash. Trunk/Hatch Pin      pink/black      -      BCM, lt. blue plug, pin B10 Notes: The BCM (Body Control Module) is under the driver dash. Hood Pin      N/A            Trunk/Hatch Release      locks/unlocks along with doors            Power Sliding Door      N/A            Factory Alarm Arm      arms on lock with door open            Factory Alarm Disarm      lt. green (driver door key cylinder)      -      BCM, purple plug, pin B3 Notes: The BCM (Body Control Module) is under the driver dash. Disarm No Unlock      see factory alarm disarm            Tachometer      white      ac      ECM, plug labeled red, pin 10 Notes: The ECM (Engine Control Module) is located near the battery, down low, between the fender and the fan under the black plastic cover. Wait to start      N/A            Brake Wire      white      +      brake switch or steering column Parking Brake      lt. blue      -      parking brake switch Horn Trigger      black      -      BCM, brown plug, pin A9 Notes: The BCM (Body Control Module) is under the driver dash. Memory Seat 1      white      +      memory module under driver seat Memory Seat 2      purple      +      memory module under driver seat Memory Seat 3      N/A      +      Interface Module:     Category: Immobilizer Bypass     Required: Yes     Type: Passlock II Part #: GMBP Alternate Part1 #: PLJX Alternate Part2 #: 556LW Alternate Part3 #: 555LW Alternate Part4 #: DesignTech 20402 Alternate Part5 #: DesignTech 29402 Notes: Interface Module:     Category: Combo Interface     Required: No     Type: Data Bus Part #: 1700G Alternate Part1 #: 457GW Notes: Can use the 1700G or 457GW to bypass the Passlock II, but it will not control the door locks on this model year. Key sense input of the 1700G is not needed when using it on GM Trucks        This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter. Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information. Kenny

Owner / Technician

KKD Garage LLC

Albany, NY 12205