clifford g4 cyber2 pinout

Hi to all This is my first post here and I hope that I dont "step on any mines" any how my question is if any of you can tell me where I can find the wiring diagram/pinout of the 20pin connector on the Clifford G4 cyber2 alarm. I have it installed and I want to dismantle it from the vehicle, so I guess that I have to reconnect some of the wires so that I'll be able to start the motor afterwards. btw - there is on the site installation guide for the G4 solaris but it a different model. btw2 - I've approached Clifford's site but I was not able to make any contact with them. not even be able to send them an Email. odd! hope that you'll be able to help.

Strange but the contents say 24 pin and the actual diagram page lists it as a 20 pin. 1     Grey (+) or (-0     Door trigger input 2     White (-)     Valet switch input 3     Orange (-)     Sensor trigger zone 1 4     Grey / YELLOW (-)     Trunk and hood 5     Blue (-)     Sensor input warn (outer zone) 6     Violet (+)     LED output 7     WHITE/ Brown (+)     Ignition input 8     Black (-)     Ground input for sensors, valet switch, LED 9     Black (-)     Unit ground 10     Red (+)     Power for external sensors 11     BROWN / white (-)     Dome (interior) light supervision 12     Grey/Green (+) or (-)     Door lock output 13     Grey/Orange (+) or (-)     Door unlock output 14     Green (-)     Armed output GWA 15     Grey/Violet (-)     Aux output 16     Yellow (-)     Siren output 17     Brown     Parking/Indicator output 18     Brown     Parking/Indicator output 19     RED / White (+)     12 Volt input 20 amp fuse 20     Red     12 Volt input 5 amp fuse I've downloaded the installation guide so please feel free to email me for it, see my profile.