oem lock unlock euring remote start

Factory remotes won't work when truck is remote started. You will need you run the unlock wire in the door. POWER LOCK      BROWN (TYPE B) See NOTE #3      @ MODULE INSIDE DRIVERS DOOR      POWER UNLOCK      GRAY (TYPE B) Requires Double Pulse      @ MODULE NOTE #3: METER THRESE WIRES WHILE TURNING KEY IN THE DRIVERS DOOR KEY CYLINDER.UNLOCK REQUIRES A DOUBLE PULSE.If i Can't Install it    I Don't need it   Joe

thanks, not answer I wanted, but I got it. So my only other option is to unlock with OEM keyless remote B4 I RS?jf durf

The problem with doing that is the truck will be unlocked the whole time it's runningIf i Can't Install it    I Don't need it   Joe

you're better off running the wires into the doors for unlock/lock. The vehicle automatically disables the factory remotes when the vehicle is running. After-all, once the vehicle is running there would be no need for factory keyless. IF you unlock with the oem remote and it starts, the doors would be unlocked. Not to mention your range would be limited to 30ft tops. The Viper remote would offer much more range. Ted

2nd Year Tier 1 Medical School

Still installing as a hobby...pays for groceries

Compustar Expert

Or use the second status output to keysense, black at ignition switch test:- Set DMM to 20 VDC, red probe to constant source, black to suspect wire, meter will read 12VDC+ on inserting key. If there's only one status wire, use a pair of 1N4004 diodes, bands towards the Viper to separate the signal.

https://www.the12volt.com/diodes/diodes.asp You need diodes to isolate the keysense and bypass module. if you didnt do this, every time a key went into the tumbler, the bypass would turn on. Not what you want.Ted

2nd Year Tier 1 Medical School

Still installing as a hobby...pays for groceries

Compustar Expert

Hmm Ted, I gave the same answer about an hour ago, seems this site doesn't talk top my iPad when I'm watching TV!