avital 4103 1996 lincoln towncar

Tomorrow I am digging into the install. I'm just wanting to check all my wiring. I'm probably forgetting something. Also, do I need relays? Diodes? Main Harness (H1), 9 Pin connector

1. Factory disarm - drk grn/prpl
2. NC
3. ignition out(to alarm) - to ignition BROWN / pink
4. activation input - NC
5. ground when locked/antigrind output - NC
6. Horn output - Drk Blue
7. trunk release - to purple / YELLOW
8. ground - chasis ground
9. light flash output - brown

Door Lock - 3 pin connector

1. unlock - to pink/light green
2. empty
3. lock - to pink / YELLOW

Heavy Gauge Relay H2, 6 pin connector

1. output to primary ignition circuit - BROWN / pink
2. output to starter circuit - WHITE/ pink
3. output to accessory circuit - BLACK/ light green
4. 30A high current 12v input - light green
5. output to second ignition / accessory circuit - pink/black
6. 30A high current 12 v input - light green

Satellite harness - 4 pin connector

1. status output - NC
2. accesory output - BLACK/ light green
3. starter output - WHITE/ pink
4. ignition output - BROWN / pink

Remote start Harness H3 5 pin connector

1. neutral safety switch input - grounded
2. tach input - pink @EDIS module
3. brake shutdown input wire - light green @ brake
4. hood pin switch shut down wire - to hood pin
5. second status/rear defogger - I want this hooked up, but i dont know where it goes.

noob

On H1 ignition out doesn't go to anything, satellite harness doesn't go to the ignition harness. The satellite harness has all negative outputs made to run external relays. Door locks are positive trigger and the 4103 has negative outputs you will need a pair of relays or a dei 451m POWER LOCK      PINK / YELLOW (TYPE A)      IN DRIVERS KICK PANEL      POWER UNLOCK      PINK/LIGHT GREEN (TYPE A)      IN DRIVERS KICK PANELIf i Can't Install it    I Don't need it   Joe

First off, Thank you Chev for the reply. Second, on the cheat sheet I printed off I saw 3 ignitions. How do I hook then up? Ign 1- primary ignition - BROWN / pink Ign 2- heat/ac - pink/black Ign 3- blower motor     - BLACK/ lt gen noob

The 4103 has 2 ignition outputs. The third you'll need the negative ignition wire from the satellite harness; and connect that to a relay as follows 85 negative ignition output 86 constant 12v fused 87 constant 12v fused at 15-20 amps 30 third ignition wireTed

2nd Year Tier 1 Medical School

Still installing as a hobby...pays for groceries

Compustar Expert

Sweet, thanks guys! Time to dig in!noob