2012 Ford Taurus w/CM7200 and Blade AL

Home / the12volt's Install Bay / Car Security and Convenience / 2012 Ford Taurus w/CM7200 and Blade AL

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

brianl62

Member - Posts: 1

Joined: August 03, 2018

Location: Colorado, United States

Posted: August 12, 2018 at 11:30 AM / IP Logged

New install on a 2012 Ford Taurus with a Push To Start ignition. I have flashed the Blade AL with DL FM5 v1.6 and I'm at the part where I attach to the car, I have the original Ford FOB (without battery) in the backup transceiver but when I put the car into the on position (long push) the blue led on the blade does not go blue. I was following the "Module Programming Procedure - One KeyFOB & KLON" procedure from idatalink.

I'm using the low current ignition CN3 connector/harness. I do not have the parking lights hooked up to the car, I'm using a multimeter to monitor the output to ground. Connector C5 is not connected. The 7200 is also grounded through the CN3 low current connector/harness.

Wiring is per this:

2012 Ford Taurus w/CM7200 and Blade AL -- posted image.

Module programming instructions:

Any ideas??

Brian

Back to Top

If you wish to post a reply to this topic, you must first login.
If you are not already registered, you must first register.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.