FLRSBA Remote Start Issue with 2008 Honda Accord

Home / the12volt's Install Bay / Car Security and Convenience / FLRSBA Remote Start Issue with 2008 Honda Accord

Welcome Guest :)

Members

< Prev Topic Next Topic >

dee99ta

Member - Posts: 1

Joined: April 07, 2004

Location: United States

Posted: March 03, 2019 at 9:06 PM / IP Logged

Trying to install a FLRSBA remote start in a 2008 accord(4 cyl sedan). I sent the first one back as the it would allow the car to start, but would die right after. It didn't appear to be bypassing the immobilizer as I could see the security LED in the dash flashing. I did the learn procedure numerous times and even reflashed the module. I got the second one in along with a new T-harness, same thing. I have installed numerous flashlogic modules but never had an issue like this. Anyone see anything like this or have some suggestions? I seen in their firmware history some notes about trying to improve programming when using the T-harness.

If you wish to post a reply to this topic, you must first login.
If you are not already registered, you must first register.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.