Sunroof and free AUX channel.

A dealer refused to do the job because the roof has "tilting". Said that it's hard to do the job even with a window module.

Please help verify that this really can NOT be done. The following is the schematic for the sunroof of Protege5.

http://216.254.182.194/12volt.jpg

I have 4 AUX channels free. All i need is to open and close the roof with my remote.

Initially i was thinking of doing it my self but when i tried to buy a window module for this, the dealer said that it was not possible to control a roof that has a tilting even with a window module.

Please help verify this by looking at the schematic.

To answer your questions "djfearny2", my car is a Mazda Protege5. It has a sunroof that is electronically controlled, check the schematic on my previous post.

As for "cpgoose" question relating to the alarm, I have the Autopage RS-850LCD.

My car is a hatch that is why i do not use channel 2 of the alarm which is the trunk release. The alarm does have channel 4,  5, 6 available for use. They can be programmed to be momentary, latched, latched ignition reset, and pulse, and timer 0.9 to 2 minutes.

Now I have another question, is it OK not to use sunroof module?

I am thinking of using channel 4 and a relay for sunroof opening and program it to be active for about 5 seconds and channel 5 and another relay for sunroof closing and program it to be active for about 5 seconds.  I have checked the roof will fully open if i hold the switch for 5 seconds and the same thing for closing.

What i am worried though is that if the time is not right the motor maybe supplied voltage more then it should. Wil my motor be damage?