the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

1994 Toyota Pickup - Clutch Bypass - Help


Post ReplyPost New Topic
< Prev Topic Next Topic >
mv577 
Member - Posts: 18
Member spacespace
Joined: December 17, 2002
Location: United States
Posted: August 27, 2003 at 7:58 AM / IP Logged  
Hello all...
I am installing a CS-2011RS alarm / remote starter into my 94 Toyota Pickup... manual transmission. It comes factory with a button on the dash that bypasses the clutch so you can start the truck without the clutch in... Can anyone help me figure out how to have my remote starter activate this???
Thanks in advance!
Mike
profuse007 
Gold - Posts: 2,015
Gold spacespace
Joined: October 20, 2002
Location: Texas, United States
Posted: August 27, 2003 at 11:08 AM / IP Logged  
i havent done that many manual, but ill try to help.
how many wires are coming out of the little switch?
if two, then one of the wire must be connect to complete the circuit. so one of the wire will not have neg or pos and the other one will have.
hope it helps
Houston,TX
"The two most common elements in the universe are H+ and stupidity" (Ellison).
jrilla 
Gold - Posts: 1,498
Gold spaceThis member has made a donation to the12volt.com. Click here for more info.spacespace
Joined: November 19, 2002
Location: North Dakota, United States
Posted: August 27, 2003 at 11:11 AM / IP Logged  
I installed a RS on a 94 T100 and all I needed to do was connect a (-) out when running to one of the wires at the switch above the clutch. It sounds like the switch on the dash is after market. The dash switch likely triggers a relay that grounds one of the wires at the switch above the pedal, so you should test the dash switch to see how it acts then duplicate the action using a (-) out when running wire and a relay, or something along that nature. Likely the dash switch will have 2 wires and the switch will simply connect the two wires, so if you wanted to duplicate that you would just use a relay with Pin 30 connected to one wire, and pin 87 to the other. then Pin 85 to a ground out when running from the starter, and Pin 86 to an Ignition source.
J Rilla
Owner/Installer
mv577 
Member - Posts: 18
Member spacespace
Joined: December 17, 2002
Location: United States
Posted: August 27, 2003 at 11:49 AM / IP Logged  
Hey thanks for the replies.... I haven't looked at the back of the switch.... but I can tell you that it isn't aftermarket... I just bought this truck from my Dad who bought it new in 94... I guess the idea behind it was to let you use the starter to help jog you out of mud etc...
it is a Toyota switch.... my guess is they didn't keep that in there for very long due to liability reasons...
So once I figure out if it's neg or pos I can use one of the outputs on the alarm / starter to activate it?
Thanks again!
Mike
profuse007 
Gold - Posts: 2,015
Gold spacespace
Joined: October 20, 2002
Location: Texas, United States
Posted: August 28, 2003 at 5:52 AM / IP Logged  
yeah, use a relay to properly bypass it.
Houston,TX
"The two most common elements in the universe are H+ and stupidity" (Ellison).

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Tuesday, May 21, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer