the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

Remote Alarm goes off after 15 sec


Post ReplyPost New Topic
< Prev Topic Next Topic >
olein 
Member - Posts: 1
Member spacespace
Joined: September 18, 2003
Location: Canada
Posted: September 18, 2003 at 12:47 AM / IP Logged  

I have a 98 Venture. A Nordic NS4503 alarm/remote starter was installed.

I have taken it back many times to get them to fix the problem I'm having. Every time I arm the alarm with the dome light main switch in the on position 15 seconds later the alarm goes off. The same thing happens when i use the remote to start it and after the van stops running the alarm goes off.

I wait 10 sec after I close the door to arm the system, but 15 sec later it goes off. Is there some thing they are missing that i can do to stop the alarm going off by it self.

NowYaKnow 
Gold - Posts: 1,217
Gold spacespace
Joined: December 18, 2002
Posted: September 18, 2003 at 5:05 AM / IP Logged  
Tell them (not that you should have too..) to put a relay off the dome light wire to your door trigger input, or to go to the seperate door triggers themselves and see what happens.
<<main switch in the on position >>
By the way does this mean ON like all the way up where the domelight just stays on all the time, or just on as in active so it goes on and off when you open the doors?
<<The same thing happens when i use the remote to start it and after the van stops running the alarm goes off.>>
See if they have the illuminated exit feature turned on or not. If so then I would turn it off so the domelight doesn't come on when the car shuts off. If they don't have that feature on then the car itself is turning it on and not a whole lot you can do. Good luck
Ixj159 
Copper - Posts: 68
Copper spacespace
Joined: March 07, 2003
Location: United States
Posted: September 18, 2003 at 7:01 PM / IP Logged  

Sounds to me they have the wrong door trigger, or u have an alarm that senses the type of trigger, so when u arm the alarm w/ the dome light still on cause many cars take like 10 sec to fade, it is negative, then when the light turns off it switchs to positive or visa vera, look at the light and see if the alarm triggers exactly when the dome light completely shuts off, iif so, thats ur problem.

Eric

Montrealler 
Copper - Posts: 155
Copper spacespace
Joined: October 05, 2002
Location: Canada
Posted: September 18, 2003 at 9:29 PM / IP Logged  
I truely think you should consider to take the door triggers input at the bcm... You will find the bcm in the passenger side kick pannel. You will need to use 3 differents wires tan for driver door, blue for passenger door and liftgate, orange for sliding door(s), use diodes to isolate each wires.
hope this will help you!
good luck

Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Saturday, May 11, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer