2001 tundra, need some tips

2001 tundra V8 sr5 fact alarm intergrated, need some tips 791xv i need some tips upon this vehicle. my diagram doesnt show much of complications, but if someone have done this car plz pinpoint out some tips on those hard to find wires. besides the unlock require 2x pulse on driver side, thanks to jworm...

anyone....Houston,TX

"The two most common elements in the universe are H+ and stupidity" (Ellison).

Tips? Its a Toyota....they don't get much easier. When did I say unlock was double pulse? 12volts      WHITE/ red or white        +       ignition harness Starter      GREEN/ black        +       ignition harness Ignition      BLACK / YELLOW        +       ignition harness Second Ignition      BLACK/ red        +       ignition harness               Accessory      blue/red        +       ignition harness Parking Lights-      RED / black              steering column Horn Trigger      GREEN/ red        -       steering column Power Lock      WHITE/ green        -       either kick panel Power Unlock      RED / yellow        -       either kick panel Lock Motor      blue/white              drivers door harness Unlock Motor      BLACK / YELLOW              drivers door harness Parking Lights+      green              drivers kick panel Door Trigger      WHITE/ blue        -       drivers door harness Dome Supervision      use door trigger               Factory Alarm Disarm      blue/black        -       drivers door harness Brake Wire      GREEN / WHITE        +       drivers kick panel Tachometer      black or blu/wht              instrument cluster, brn plug Notes: It is black on the 6 cylinder models, and blue/white on the 8 cylinder models, at the instrument cluster. On the 4.7L V8 can also use BLACK/ blue at coil #1 on the drivers side. What are you doing to the truck? Alarm, remote start, both? If the lights have an "AUTO" option on the switch, you will need to factor that in when doing remote start. If the remote start times out, the lights will stay on until a door is opened. If you never open a door, the lights will stay on until the battery dies. Dumb design by Toyota. I can explain how to get around it if you need me to.

nvm...i was searched through a wrong thing... its a viper 791xv, so both alarm and rs so i guess its a straight forward install tomrorow. it would be cool if you could explain about how to disable the "AUTO" light after remote start, i may have to run into it if not next time. Houston,TX

"The two most common elements in the universe are H+ and stupidity" (Ellison).

thanks jworm

The following will turn off the AUTO lamps after the remote start shuts off either by remote or by shutting down after the programmed time. 86: +12 volts 85: (-) rearm output from remote start 87: ground 30: Drivers door trigger. You need to use the true door trigger, not the one listed in the diagram above. Remove the factory pin switch to see the color of the wire. If you are doing an alarm / remote start, its harder. Problem is pulsing ground to the door trigger will trigger the alarm. Solution is to cut the drivers door trigger, insert a diode inline (stripe toward door pin switch), and connect 30 from the relay above on the non-stripe side of the diode. Connect your door trigger wire from the alarm to the pin switch side (stripe side). Other option is to keep light switch in off position when truck is off instead of in the AUTO position.

thanks jworm, the install today works out great, theres no auto light thingy. koo, got it. didnt think of putting the diode. i thought of pulsing the trigger, too but the alarm will go off, like you mention.