Wiring Diagram Needed:03 Hyundai Santa fe

I need the wiring diagram for  ahyundai santa fe 2003 for an alarm/remote start/keyless entry. I cannot find it on the website. Thanx guys.

12volts red & orange + ignition harness

Starter  blue   +   ignition harness     Second Starter  N/A           Ignition  blue   +   ignition harness     Second Ignition  pink   +   ignition harness     Third Ignition  N/A           Accessory  green   +   ignition harness     Second Accessory  N/A           Keysense  brown   +   ignition harness     Power Lock  yellow   -   DKP, white 22 pin plug     Power Unlock  WHITE/ black   -   DKP, white 22 pin plug     Lock Motor  gray   5wi  DKP, white 22 pin plug     Unlock Motor  white   5wi  DKP, white 22 pin plug     Parking Lights+  GREEN/ orange   +   fuse box, 15 pin plug     Parking Lights-  white   -   headlight switch     Hazards  green (only w/fac. alarm)   -   ETACS, 12 pin plug    Turn Signal(L)  pink   +   steering column     Turn Signal(R)  gray   +   steering column     Reverse Light  blue/black   +   fuse box, top right plug     Door Trigger  yellow   -   fuse box, 8 pin plug     Dome Supervision  use door trigger           Trunk/Hatch Pin  BLACK/ orange   -   fuse box, 15 pin plug     Hood Pin  pink   -   ETACS, 12 pin plug    Trunk/Hatch Release  N/A           Power Sliding Door  N/A           Factory Alarm Arm  factory remote only           Factory Alarm Disarm  factory remote only           Disarm No Unlock  disarms with remote start           Tachometer  WHITE/ black or blue   ac   ECM    Wait to start  N/A           Brake Wire  GREEN/ black   +   brake pedal switch     Parking Brake  green   -   parking brake switch     Horn Trigger  brown   -   steering column     Memory Seat 1  N/A           Memory Seat 2  N/A           Memory Seat 3  N/A

Hazards :The ETACS module is attached to the back of the fuse box on the bottom.

Hood Pin :The ETACS module is attached to the back of the fuse box on the bottom.

The hood pin is also green at the switch under the hood.

Tach. :The ECM (Engine Control Module) is under the center console to the right of the gas pedal. On the 2.4L with A/T is it in the 26 pin plug, the 2.4L with M/T it is in the 12 pin plug, and the 2.7L it is in the 40 pin plug.

thanx much

rudbwoy69camaro wrote:       Factory Alarm Arm  factory remote only            Factory Alarm Disarm  factory remote only            Disarm No Unlock  disarms with remote start

So If you want to install keyless with remote start, is it possible to disarm the factory security somehow using the aftermarket system? Or do you need to leave the factory system disabled?