2 Sirens, Horn, Setup Problems

ok you have the relay with the pezio and siren hook up to the brown siren output wire right?

o.k., you will need two more relays to hook up your horn.

relay # 1

86& 87 go to fused 12v constant

85 goes to the orange wire from the 3.5x (ground when armed)

30 goes to relay # 2's 86

(the rest of relay#2)

87 goes to (-) if the horn is negative trigger/goes to (+) if the horn is positive trigger.( make sure you verify this with your dmm. )

30 goes to the horn trigger wire of the vehicle

85 goes to the BLACK/ white from the 3.5x (this is the domelight supervision wire and will provide your pulsed output for the horn to honk.)

good luck and have fun.

also, if you have any other security components (window mods, motion sensor, digital tilt sensor, ect.) make sure you diode isolate each component from one another to prevent backfeeding and undesired operation.

 also, if you arm the vehicle, then remote start the vehicle, then disarm the vehicle to get in, and the horn starts to go off constant (not pulsed) then go to the program menu (in the install guide) and program OFF the ant-grind .