Status input wire? 555L remote start

Home / the12volt's Install Bay / Car Security and Convenience / Status input wire? 555L remote start (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

blazer2

Member - Posts: 21

Joined: December 23, 2003

Location: United States

Posted: March 29, 2004 at 12:16 PM / IP Logged

Just wiring up this 555L on my blazer and wonder what I connect this status input to? According to the installation manual it says connect it to the status output of of a DEI remote start system, but there isnt a wire for that from my G5. Im wondering if its ok to leave it disconnected?

00 Blazer Zr2 - Custom Box, Excelon 859, Clifford G5

91 Explorer - Alpine, Rattler

87 Rx7 - OEM except under the hood

blazer2

Member - Posts: 21

Joined: December 23, 2003

Location: United States

Posted: March 29, 2004 at 2:31 PM / IP Logged

Ok, I just searched around, and found a few confusing answers.

One person said to connect the wire to your ignition 2, but this wire shows +12v when the input requires (-).

Another person suggested the negative ignition wire, but I wasnt aware there was a wire like this on the car.

2000 Blazer. I'll go dig some more.

00 Blazer Zr2 - Custom Box, Excelon 859, Clifford G5

91 Explorer - Alpine, Rattler

87 Rx7 - OEM except under the hood

laren5

Copper - Posts: 57

Joined: June 10, 2003

Location: Aruba

Posted: March 29, 2004 at 2:36 PM / IP Logged

There is a blue/orange wire on the H3 connector of the intellistart. You should use that blue/orange for your status output (connect this to the 555L)

Good luck

Clifford Alarms

kgerry

Platinum - Posts: 3,455

This member consistently provides reliable information

Joined: February 07, 2004

Location: Saskatchewan, Canada

Posted: March 30, 2004 at 2:28 PM / IP Logged

any wire that says "ground out while running"

Kevin Gerry

Certified Electronics Technician

MECP First Class Installer

Owner/Installer

Classic Car Audio

since 1979

sroth140

Silver - Posts: 513

Joined: August 27, 2003

Location: United States

Posted: March 30, 2004 at 3:10 PM / IP Logged

even a factory disarm wire would work, but on most DEI brains its a blue or blue/black wire.

MECP certified installer

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Status input wire? 555L remote start

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.