Window Module with SPAL Window Kit

Hi, On my '94 Celica, I have a SPAL deluxe power window kit installed. It works perfectly, and from each window motor, I have a blue wire and a black wire. These, along with +12volts and ground, go to each of the two window switches. Today, I started installing a CL-200 power window module which has the following wires: Blue - 1st Window Switch Green - 1st Window Motor Red - Fused +12 Volts Black - Ground Yellow - (-)Input From Alarm Brain Blue/White - 2nd Window Switch GREEN / WHITE - 2nd Window Motor Yellow/White - To starter kill relay Orange - (+)Input From Alarm Brain(Optional) Now, since I have SPAL power windows in my car with a blue and black wire coming from each window motor, I'm not sure where the blue and green and blue/white and GREEN / WHITE wires from my module go. Also, I currently don't have a starter kill relay, and so I'm not using the yellow/white wire. This shouldn't affect anything, right?

your blue and green wires go to your drivers motor wires  green to window motor same for passenger side you will just use the white striped in pass door  cut the  wire on your motor that tests 12volts in the up direction and install as above tj

I just tested the wires on the kit, and the black wires coming from the motors are the ones that give +12 volts when the windows are rolling up. So the green and GREEN / WHITE wires will go to these black wires? If I do that, then where exactly will the blue and blue/white wires go?

Thanks for the help TJ, I got it figured out and installed today.