Automate and 551t remote start problems

Home / the12volt's Install Bay / Car Security and Convenience / Automate and 551t remote start problems (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

my68ur8trd

Member - Posts: 1

Joined: June 23, 2004

Location: United States

Posted: June 29, 2004 at 12:05 AM / IP Logged

installed a older 551t with an older automate 410. if the alarm is armed and the remote start is started, the alarm goes off. i did not connect the status or accessory wire to anything. i wasnt sure where to connect them. please help

Justin

sroth140

Silver - Posts: 513

Joined: August 27, 2003

Location: United States

Posted: June 29, 2004 at 1:43 AM / IP Logged

you have to isolate the shock harness during remote start. im not sure about what to do with the automate, but if the alarm has an external shock sensor, you can use a relay to interrupt the (+) or (-) wire on the sensor to cut power to it.

MECP certified installer

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Automate and 551t remote start problems

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.