Connecting Multiple Modules

Home / the12volt's Install Bay / Car Security and Convenience / Connecting Multiple Modules (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

Tengoku

Member - Posts: 6

Joined: March 28, 2004

Location: United States

Posted: July 19, 2004 at 10:33 PM / IP Logged

The alarm unit only has one input for a 3 wire connection which is used by an impact sensor... however, I bought a motion detector and would like to install this as well as the impact sensor..

If I wanted to do this... how would I go about doing this? would I Just splice into the 3 wires connected into the alarm unit and connnected the appropriate wires? can I do this with multiple modules??

Back to Top

JWorm

Platinum - Posts: 2,208

Joined: December 11, 2002

Location: New Hampshire, United States

Posted: July 20, 2004 at 12:01 AM / IP Logged

Get power and ground from a different source. You can use the same trigger wire, but you will need to diode isolate the two wires from each other. Read the section here on the top left about diodes.

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Connecting Multiple Modules

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.