keyless entry programing

Home / the12volt's Install Bay / Car Security and Convenience / keyless entry programing (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

cacheli1266

Member - Posts: 1

Joined: August 25, 2004

Posted: August 25, 2004 at 11:25 AM / IP Logged

how do i program a keyless entry remote for a lincoln navigator 98...

thanks

mo12v

Platinum - Nominee - Posts: 2,748

This member consistently provides reliable information

Joined: September 30, 2003

Location: Afghanistan

Posted: August 25, 2004 at 6:33 PM / IP Logged

1998 (Windstar/Escort/Tracer/Navigator): Cycle the ignition from OFF to RUN/ACC eight (8) times within 10 seconds, ending in RUN/ACC, or cycle the ignition from OFF to START four (4) times within 10 seconds, ending in RUN. The power door locks should cycle LOCK to UNLOCK to confirm entrance into Program Mode.

2. Press any button on a remote entry transmitter. The power door locks should cycle LOCK then UNLOCK to acknowledge transmitter code.

3. Repeat Step 2 for any additional remote entry transmitters that need to be programmed to the vehicle.

4. Turn the ignition switch to OFF to exit Program Mode. To confirm Program Mode has been exited, the power door locks will cycle LOCK then UNLOCK one last time.

Don't Learn from Others Mistakes

You Might Be the One That Knows.

mo12v

Platinum - Nominee - Posts: 2,748

Joined: September 30, 2003

Location: Afghanistan

Posted: August 25, 2004 at 6:34 PM / IP Logged

That is if you are programming the correct FACTORY Remote

Don't Learn from Others Mistakes

You Might Be the One That Knows.

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

keyless entry programing

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.