2001 Cadillac Seville with GMDL-DP

Home / the12volt's Install Bay / Car Security and Convenience / 2001 Cadillac Seville with GMDL-DP (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

halfrican

Member - Posts: 15

Joined: June 23, 2004

Location: United States

Posted: October 06, 2004 at 5:47 PM / IP Logged

Hello All,

Just had an AstroStart 4204 remote start installed in my 2001 Cadillac Seville STS. Installer used the Peripheral GMDL-BP module to interface with my factory remote keyless entry and to bypass the Passkey III. The module is successfully locking and unlocking my doors and bypassing the Passkey III, but doesn't appear to be able to trigger the Memory Seat/Mirror functions of the car as it advertises that it does.

Installer has double checked the programming of the module, and even attempted to swap it out with a new one, but to no avail.

Anyone have any experience working with these or similar modules on a Seville STS of a similar year?

Also installer used one of the accessory outputs of the remote start to trigger the rear window defrost (8 minute cycle), but it doesn't appear to heat the mirrors and doesn't lite up the button on the HVAC. He accessed the defrost under the rear seat using a purple wire if I remember correctly. Any other ideas on what might be missing?

Thanks in advance,

Mark

(Alaska)

Teken

Gold - Posts: 1,492

Joined: August 04, 2002

Location: Aruba

Posted: October 06, 2004 at 5:56 PM / IP Logged

Ask him how the rear defroster was interfaced, and at what point in the circuit.

Regards

EVIL Teken . . .

Teken

Gold - Posts: 1,492

Joined: August 04, 2002

Location: Aruba

Posted: October 06, 2004 at 6:05 PM / IP Logged

DIRECTWIRE™ WIRING INFORMATION - CADILLAC / SEVILLE / 2001 / Remote Start

12volts orange or orn/blk + ignition harness

Notes: This is a low current 12V source that should not be used to drive any high current positive circuits.

The ignition harness is accessed by removing, but not unplugging the radio.

Starter yellow + ignition harness

Notes: The ignition harness is accessed by removing, but not unplugging the radio.

Second Starter

Ignition pink + ignition harness

Notes: The ignition harness is accessed by removing, but not unplugging the radio.

Second Ignition white + ignition harness

Notes: The ignition harness is accessed by removing, but not unplugging the radio.

Third Ignition

Accessory orange + ignition harness

Notes: The ignition harness is accessed by removing, but not unplugging the radio.

Second Accessory brown + ignition harness

Notes: The ignition harness is accessed by removing, but not unplugging the radio.

Keysense

Power Lock RED / black - drivers door lock switch

Notes: Can also use Directed 456B interface module.

Power Unlock ORANGE / black - drivers door lock switch

Notes: Can also use Directed 456B interface module.

Lock Motor gray drivers door module

Notes: The drivers door module is located above the speaker in the drivers door.

Unlock Motor tan drivers door module

Notes: The drivers door module is located above the speaker in the drivers door.

Parking Lights+ do not use

Parking Lights- BROWN / white DIM module

Notes: The DIM module is located just in front of the blower motor near the passenger kick. It has three connectors that all exit out of the bottom of the module.

Hazards

Turn Signal(L)

Turn Signal(R)

Reverse Light

Door Trigger -

Notes: The drivers door trigger wire is tan at the drivers door module, and the other door triggers are dk. blue at their respective door modules.

Dome Supervision gray - underdash light

Trunk/Hatch Pin black - RIM module

Notes: The RIM module is located behind the rear seat in the lower corner on the passenger side.

Hood Pin

Trunk/Hatch Release lt. blue - RIM module

Notes: The RIM module is located behind the rear seat in the lower corner on the passenger side.

Power Sliding Door

Factory Alarm Arm

Factory Alarm Disarm lt. green - drivers door module

Notes: The drivers door module is located above the speaker in the drivers door.

Disarm No Unlock

Tachometer PURPLE / white ign. coil on top of motor

Wait to start

Brake Wire white + low in drivers kick

Parking Brake

Horn Trigger black - DIM module

Notes: The DIM module is located just in front of the blower motor near the passenger kick. It has three connectors that all exit out of the bottom of the module.

Memory Seat 1

Memory Seat 2

Memory Seat 3

Immobilizer Bypass Module: Required: Yes Type: Passkey 3 Part #: 555G, 556U, or 555U

Notes: N/A

There are (2) accessory wires that need to be powered as well. Ask the installer to confirm both are connected and powered during the RS.

Regards

EVIL Teken . . .

halfrican

Member - Posts: 15

Joined: June 23, 2004

Location: United States

Posted: October 06, 2004 at 6:10 PM / IP Logged

Teken wrote:

DIRECTWIRE™ WIRING INFORMATION - CADILLAC / SEVILLE / 2001 / Remote Start

12volts orange or orn/blk + ignition harness

Notes: This is a low current 12V source that should not be used to drive any high current positive circuits.

The ignition harness is accessed by removing, but not unplugging the radio.

Starter yellow + ignition harness

Notes: The ignition harness is accessed by removing, but not unplugging the radio.

Second Starter

Ignition pink + ignition harness

Notes: The ignition harness is accessed by removing, but not unplugging the radio.

Second Ignition white + ignition harness

Notes: The ignition harness is accessed by removing, but not unplugging the radio.

Third Ignition

Accessory orange + ignition harness

Notes: The ignition harness is accessed by removing, but not unplugging the radio.

Second Accessory brown + ignition harness

Notes: The ignition harness is accessed by removing, but not unplugging the radio.

Keysense

Power Lock RED / black - drivers door lock switch

Notes: Can also use Directed 456B interface module.

Power Unlock ORANGE / black - drivers door lock switch

Notes: Can also use Directed 456B interface module.

Lock Motor gray drivers door module

Notes: The drivers door module is located above the speaker in the drivers door.

Unlock Motor tan drivers door module

Notes: The drivers door module is located above the speaker in the drivers door.

Parking Lights+ do not use

Parking Lights- BROWN / white DIM module

Notes: The DIM module is located just in front of the blower motor near the passenger kick. It has three connectors that all exit out of the bottom of the module.

Hazards

Turn Signal(L)

Turn Signal(R)

Reverse Light

Door Trigger -

Notes: The drivers door trigger wire is tan at the drivers door module, and the other door triggers are dk. blue at their respective door modules.

Dome Supervision gray - underdash light

Trunk/Hatch Pin black - RIM module

Notes: The RIM module is located behind the rear seat in the lower corner on the passenger side.

Hood Pin

Trunk/Hatch Release lt. blue - RIM module

Notes: The RIM module is located behind the rear seat in the lower corner on the passenger side.

Power Sliding Door

Factory Alarm Arm

Factory Alarm Disarm lt. green - drivers door module

Notes: The drivers door module is located above the speaker in the drivers door.

Disarm No Unlock

Tachometer PURPLE / white ign. coil on top of motor

Wait to start

Brake Wire white + low in drivers kick

Parking Brake

Horn Trigger black - DIM module

Notes: The DIM module is located just in front of the blower motor near the passenger kick. It has three connectors that all exit out of the bottom of the module.

Memory Seat 1

Memory Seat 2

Memory Seat 3

Immobilizer Bypass Module: Required: Yes Type: Passkey 3 Part #: 555G, 556U, or 555U

Notes: N/A

There are (2) accessory wires that need to be powered as well. Ask the installer to confirm both are connected and powered during the RS.

Regards

EVIL Teken . . .

Thanks for the quick reply, I will show this to installer. Do you have any experience with the Peripheral GMDL-DP interface/bypass module? Should it not be activating the memory seat function thru the databus connection?

thanks,

Mark

mo12v

Platinum - Nominee - Posts: 2,748

This member consistently provides reliable information

Joined: September 30, 2003

Location: Afghanistan

Posted: October 06, 2004 at 6:39 PM / IP Logged

I beleive on the Module U can program OPTIONS by the Program / Option button............

They have a Tech service 1 800 477-2267

Don't Learn from Others Mistakes

You Might Be the One That Knows.

halfrican

Member - Posts: 15

Joined: June 23, 2004

Location: United States

Posted: October 06, 2004 at 6:45 PM / IP Logged

mo12v wrote:

I beleive on the Module U can program OPTIONS by the Program / Option button............

They have a Tech service 1 800 477-2267

Made sure that module was set to Mode 3 (Seville) didn't seem to help. It's acting like it is working cause of the door locks and trunk release, but still doesn't activate memory seat/mirrors.

Tech support not very helpful.

mo12v

Platinum - Nominee - Posts: 2,748

Joined: September 30, 2003

Location: Afghanistan

Posted: October 06, 2004 at 7:28 PM / IP Logged

I know you set the Module to Mode 3, but I think there is another setting for OPTIONS......Do U have insstructions?

I thought U set your Mode # (vehicle) 1st....then Option # next

I would try Tech again, and definitly get the Techs NAME.........

Don't Learn from Others Mistakes

You Might Be the One That Knows.

halfrican

Member - Posts: 15

Joined: June 23, 2004

Location: United States

Posted: October 06, 2004 at 7:46 PM / IP Logged

mo12v wrote:

I know you set the Module to Mode 3, but I think there is another setting for OPTIONS......Do U have insstructions?

I thought U set your Mode # (vehicle) 1st....then Option # next

I would try Tech again, and definitly get the Techs NAME.........

Instructions for options:

1) Domelight Polarity

2) Unlock Mode (unlock drivers/unlock all)

3) Reset

extreme1

Silver - Posts: 1,070

Joined: February 12, 2003

Location: Canada

Posted: October 07, 2004 at 12:22 AM / IP Logged

So far I've found that none of the modules control anything but locl/unlock arm/diarm bypass and trunk when applicable. I have not seen one yet the does memory seats, heated seats etc.

Shaughn Murley

Install Manager, Dealer Services

Visions Electronics

Red Deer, Alberta

halfrican

Member - Posts: 15

Joined: June 23, 2004

Location: United States

Posted: October 07, 2004 at 12:26 AM / IP Logged

extreme1 wrote:

So far I've found that none of the modules control anything but locl/unlock arm/diarm bypass and trunk when applicable. I have not seen one yet the does memory seats, heated seats etc.

Strange since the website specifically says that it will.

Mark

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

2001 Cadillac Seville with GMDL-DP

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.