gmdl-bp?

Home / the12volt's Install Bay / Car Security and Convenience / gmdl-bp? (

Topic Closed)

Welcome Guest :)

Members

Next Page > < Prev Topic Next Topic >

sahall32

Member - Posts: 11

Joined: October 09, 2004

Location: United States

Posted: October 09, 2004 at 9:56 PM / IP Logged

I'm installing a alarm/remote start combo and have the gmdl-bp to interface the data bus. I have one question about the connections on the gmdl-bp. On the pink wire it states * dome light input from vehicle* would that be the dome light wire from the alarm/rs unit or from the actual vehicle?

thanks, Steve

Dauber

Copper - Posts: 97

Joined: November 11, 2003

Location: Canada

Posted: October 09, 2004 at 10:21 PM / IP Logged

Sahall32 I have done a few of these units and what that means is that you have to find a domelight source from the vehicle to go to this pink wire, then it will give you door triggers on the output of the GMDL-BP. It works pretty good, kinda like the old GMDAA's if you have ever used one. But let me know what kind of vehicle, maybe I can tell you the domelight wire. Hopefully this helps you.

Kyle@Audio Obsession Sound

sahall32

Member - Posts: 11

Joined: October 09, 2004

Location: United States

Posted: October 09, 2004 at 10:30 PM / IP Logged

that was kinda stupid huh??

2004 trailblazer

Dauber

Copper - Posts: 97

Joined: November 11, 2003

Location: Canada

Posted: October 11, 2004 at 1:44 AM / IP Logged

That one I don't know but hopefully you found it by now! But its never a stupid question to ask, especially if your unsure, better safe than sorry, especially on a vehicle like that!

Kyle@Audio Obsession Sound

Teken

Gold - Posts: 1,492

Joined: August 04, 2002

Location: Aruba

Posted: October 11, 2004 at 2:39 AM / IP Logged

DIRECTWIRE™ WIRING INFORMATION - CHEVROLET / TRAILBLAZER / 2004 / Remote Start

12volts red (40A), RED / white (40A) + ignition harness

Starter yellow + ignition harness

Second Starter N/A

Ignition pink + ignition harness

Second Ignition white + ignition harness

Third Ignition N/A

Accessory orange + ignition harness

Second Accessory brown + ignition harness

Keysense lt. green - ign harn or BCM, tan plug, pin E3

Notes: The BCM is attached to the fuse box under the left rear seat.

Power Lock use Directed module 455G

Notes: If Directed module 455G is not available, refer to DirectFax document 1053.

Power Unlock see power lock

Lock Motor gray 5wi driver door module in door

Unlock Motor tan 5wi driver door module in door

Parking Lights+ brown + fuse box under left rear seat

Parking Lights- gray/black - switch or BCM, tan plug, pin E5

Notes: The BCM is attached to the fuse box under the left rear seat.

Hazards white - steering column

Turn Signal(L) dk. green + steering column

Turn Signal(R) lt. green + steering column

Reverse Light lt. green + fuse box under left rear seat

Door Trigger gray/black + fuse box under left rear seat
Notes: To avoid dome light delay, use the separate door trigger wires. The LF door is gray/black (-) at the driver door module in the door. The RF door is BLACK/ white (-) at the passenger door module in the door. The LR door is lt. blue/black (-), and the RR door is lt. GREEN/ black (-). The rear door trigger wires are at the fuse box under the left rear seat. Use all four wires and diode isolate each.
Dome Supervision comes on with disarm

Trunk/Hatch Pin common with door trigger wire

Notes: To avoid dome light delay, use the separate trigger wires at the liftgate module in the liftgate. The liftgate is pink/black (-), and the glass hatch is purple (-). Use both wires and diode isolate each.

Hood Pin pink/black (export only) - switch or BCM, tan plug, pin E6

Notes: The BCM is attached to the fuse box under the left rear seat.

Trunk/Hatch Release N/A

Power Sliding Door N/A

Factory Alarm Arm arms with 455G

Factory Alarm Disarm disarms with 455G

Disarm No Unlock lt. green (if no 455G) - driver door module in door

Tachometer white ac PCM

Notes: 4.2L: The PCM is attached to the driver side of the engine. Tach is in the blue plug, pin 49.

5.3L: The PCM is near the lower front driver side of the engine. Tach is in the green plug, pin 10.

Wait to start N/A

Brake Wire white + brake pedal switch

Parking Brake lt. blue - switch or BCM, blk plug, pin A4

Notes: The BCM is attached to the fuse box under the left rear seat.

Horn Trigger BLACK / YELLOW to black - column or BCM, tan plug, pin E12

Notes: The BCM is attached to the fuse box under the left rear seat.

Memory Seat 1 white + driver door module in door

Memory Seat 2 purple + driver door module in door

Memory Seat 3 N/A +

Immobilizer Bypass Module: Required: Yes Type: Passlock 2 Part #: 555L or 555T

Notes: The Passlock 2 wire colors are yellow, ORANGE / black (to black), and RED / white (not used).

This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter.

sahall32

Member - Posts: 11

Joined: October 09, 2004

Location: United States

Posted: October 14, 2004 at 2:26 PM / IP Logged

I appreciate all the help so far. I do have a gmdaa module on hand will that work ok with that vehicle?

Steve

Dauber

Copper - Posts: 97

Joined: November 11, 2003

Location: Canada

Posted: October 14, 2004 at 11:51 PM / IP Logged

Just a question but on the GMDAA does it say it will do a trailblazer, I'm pretty sure that it will do it, but one question, or I should say make sure that is a version 2.7 or up, or a 2.4, otherwise you might wind up into some difficulties. Otherwise using the GMDAA is like pie. You'll see what I mean once you install it. Let me know how it goes.

Kyle@Audio Obsession Sound

sahall32

Member - Posts: 11

Joined: October 09, 2004

Location: United States

Posted: October 15, 2004 at 12:37 PM / IP Logged

It syas it will fit the 04 trailblazer and the gmdaa is version 2.8. Should that work ok without any problems.

sparkie

Platinum - Posts: 2,061

Joined: November 06, 2003

Location: Canada

Posted: October 15, 2004 at 4:34 PM / IP Logged

Yes it will. The GMDL-BP isn't recommended on the Trailblazers and Envoys. The manufacturers are having problems on these vehicles with that module. They say they are coming out with a revised version shortly. The only problem you may have is if you have a 8 cylinder motor. I had a few people tell me the GMDAA doesn't like those motors.

sparky

Dauber

Copper - Posts: 97

Joined: November 11, 2003

Location: Canada

Posted: October 16, 2004 at 10:16 AM / IP Logged

That should work perfect.

Kyle@Audio Obsession Sound

Next Page >

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.