Toyota 4Runner 1999
Remote start / Security / GPS
Wire/Function Colour Location/Description Polarity
PASSIVE ANTI-THEFT YES TRANSPONDER SEE NOTES
12 VOLTS White or WHITE/ red Ignition harness +
IGNITION BLACK / YELLOW Ignition harness +
IGNITION 2 BLACK/ red Ignition harness +
ACCESSORY Runs with ignition Ignition harness +
STARTER GREEN/ black Ignition harness +
TACH See notes*
LOCK BROWN / white In driver's kickpanel -
UNLOCK Blue/black & RED / blue** In driver's kickpanel -
DOORPIN SEE NOTES***
TRUNK PIN Lt.GREEN/ red In driver's kickpanel -
TRUNK RELEASE Manual release
FACTORY ARM Arms with lock wire
FACTORY DISARM Disarms with unlock wires
BRAKESWITCH GREEN / WHITE At switch above brake pedal +
PARKLIGHTS Green At light switch harness +
HAND BRAKE RED / white At plug on handbrake lever -
HORN GREEN/ red At steering column -
CLUTCH SWITCH BLACK/ white At switch on clutch pedal TYPE 1
DRIVER WINDOW UP Lt.green At main window switch REV POL
DRIVER WINDOW DOWN Blue / YELLOW At main window switch REV POL
PASSENGER WINDOW UP RED / black At main window switch REV POL
PASSENGER WINDOW DOWN RED / green At main window switch REV POL
LEFT REAR WINDOW UP RED / blue At main window switch REV POL
LEFT REAR WINDOW DOWN RED / yellow At main window switch REV POL
RIGHT REAR WINDOW UP Yellow At main window switch REV POL
RIGHT REAR WINDOW DOWN Green At main window switch REV POL
HEADLIGHTS RED / yellow At light switch harness -
REVERSE LIGHTS RED / white In driver's kickpanel +
DIMMER WHITE/ green At dimmer switch harness
VSS WIRE GREEN/ orange**** At ECM behind glove box****
KEY SENSE Yellow/red Ignition harness -
Vehicle notes
PLEASE NOTE: This vehicle may be equipped with a IMMOBILIZER passive anti-theft system. Please refer to our security diagram before installing any remote start products.
* On the 2.7L engine there are 2 coils on the right front of the engine. Use the BLACK/ RED or BLACK/ BLUE for a 2 cylinder signal. On the 3.4L, the tach is BLACK at the igniter on the right side of the engine (6 cylinder signal).
You can also find a tach reference at the ECM module behind the glovebox. On the 2.7L, BLACK at pin-15 of the 26-pin connector.
** Both these wires must be connected and isolated with 2 IN4001 diodes. This will require 2 pulses to unlock the doors.
*** Doorpins are independent. Driver's door is BLACK in driver's kickpanel, rear doors are BLACK/ RED in driver's kick and BLACK/ WHITE is passenger door on back of fuse panel.
**** The GREEN/ ORANGE vss wire is located at the ECM behind the glovebox. On the 2.7L, pin-8 of the 22-pin connector. On the 3.4L, pin-22 of the 28-pin connector.
Note: The information on this sheet is provided to you on an as is basis with no representation or warranty of accuracy whatsoever. It is the sole responsibility of the installer to check and verify any circuit before connecting to it. Only a computer safe logic probe or digital multimeter should be used. Wiremagic.com Corporation and/or any associated or unassociated individual or corporation who furnishes this document and/or software assumes absolutely no liability or responsibility whatsoever pertaining to the accuracy or currency of the information supplied. The installation in each and every case is the sole responsibility of the installer performing the work and Wiremagic.com Corporation and/or any associated or unassociated individual or corporation assumes no liability or responsibility whatsoever resulting from any type of installation, whether performed properly, improperly, or in any other way. The information supplied is a guide only.
--------------------------------------------------------------------------------
©2002 Autoland All rights reserved
Printed at: 10/11/2004 10:18:57 PM