wiring diagram

Home / the12volt's Install Bay / Car Security and Convenience / wiring diagram (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

khal2baba

Member - Posts: 7

Joined: September 13, 2004

Location: Canada

Posted: October 18, 2004 at 1:12 PM / IP Logged

Hi Iam trying to install this compustar cm3000 to my ford escape 2002 need

complit wiring diagram anyone can help me out please

thanks wiring diagram -- posted image.

Back to Top

snguyen

Silver - Posts: 281

Joined: October 09, 2003

Location: United States

Posted: October 18, 2004 at 1:16 PM / IP Logged

Ford

Escape

2001-2002

Remote Starter Wiring Colors and Notes
Function	Vehicle Color	Location
Start:	TAN/LT. BLUE	IGNITION SWITCH HARNESS *
Ignition #1:	LT. GREEN/ PURPLE	IGNITION SWITCH HARNESS
Ignition #2:	Brown or Gry/Yel	***
Ignition #3:	N/A
Accessory:	BLACK/ LT. GREEN	IGNITION SWITCH HARNESS
Brake Light:	LT. GREEN (+)	AT SWITCH ABOVE BRAKE PEDAL
Tach Signal:
Parking Lights:	BROWN (+)	DRIVER'S KICK PANEL
Headlights:	RED / WHITE (-)	SWITCH, STEERING COLUMN OR # PIN PLUG AT GEM **
OEM Alarm Disarm:	BLUE/LT. GREEN (-)	IN # PIN PLUG AT GEM MODULE **
OEM Alarm Arm:	LT. GREEN/ BLACK (-)	IN # PIN PLUG AT GEM MODULE **
Diesel Glow Plug:	N/A
Clutch Bypass Wire:
Notes:	* This vehicle is equipped with a transponder immobilizer system. See Installation Note #144 Bypassing Transponder Theft Systems. GEM Module Is Located On The Floor Behind The Center Console To The Right Of The Gas Pedal. Remove The Black Plastic Panel And Remove The Carpeting Covering It. *Ign2 Brown or Gry / YELLOW not present in all vehicles.

Ford

Escape

2001-2002

Alarm and Keyless Entry Wiring Colors and Notes
Function	Vehicle Color	Location
Constant +12 Volts:	RED / LT. BLUE	IGNITION SWITCH HARNESS
Starter Kill:	TAN/LT. BLUE	IGNITION SWITCH HARNESS *
Ignition +12 Volts:	LT. GREEN/ PURPLE	IGNITION SWITCH HARNESS
Dome Lights/Superv:	PURPLE / LT. GREEN (-)	IN # PIN PLUG AT GEM MODULE **
OEM Horn:	YELLOW/LT. GREEN (-)	STEERING COLUMN HARNESS
Power Lock:	PINK/WHITE	DRIVER'S KICK OR # PIN PLUG AT GEM MODULE ***
Power Unlock:	PINK/WHITE	DRIVER'S KICK OR # PIN PLUG AT GEM MODULE ***
Trunk Release:	N/A
Alarm Input Wire:	PURPLE / LT. GREEN (-)	IN # PIN PLUG AT GEM MODULE **
Notes:	*** Single Wire System, A Negative Pulse Through A 1,000 Ohm Resistor Locks The Doors. A Negative Pulse Unlocks The Doors. Diode Isolate Each Wire With The Band Of The Diodes Facing The Alarm/Remote Start Module. See Note #211

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

wiring diagram

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.