Auto Starter install

Home / the12volt's Install Bay / Car Security and Convenience / Auto Starter install (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

Tim1609

Member - Posts: 2

Joined: November 11, 2004

Location: United States

Posted: November 11, 2004 at 7:53 PM / IP Logged

I`m looking for a wiring diagram for my 2003 Dodge Ram P/U 4X4 Auto Diesel Reg Cab. Any help would be great. Thanks, Tim

daniel2002p

Silver - Posts: 524

Joined: October 10, 2003

Location: United States

Posted: November 11, 2004 at 11:12 PM / IP Logged

Dodge

Ram Pickup

2002-2003

Remote Starter Wiring Colors and Notes
Function	Vehicle Color	Location
Start:	YELLOW	IGNITION SWITCH HARNESS
Ignition #1:	BLUE (16 AWG)	IGNITION SWITCH HARNESS
Ignition #2:	RED	IGNITION SWITCH HARNESS
Ignition #3:	GREEN & ORANGE (2 WIRES)	IGNITION SWITCH HARNESS
Accessory:	BLACK/ WHITE & BLUE (2 WIRES)	IGNITION SWITCH HARNESS
Brake Light:	WHITE/ TAN	AT SWITCH ABOVE BRAKE PEDAL
Tach Signal:	TAN/RED	AT IGNITION COIL
Parking Lights:	PURPLE / YELLOW	HEADLIGHT SWITCH*
Headlights:	PURPLE / YELLOW	HEADLIGHT SWITCH *
OEM Alarm Disarm:	LT. GREEN/ ORANGE *****	HARNESS COMING IN FROM DRIVER'S DOOR
OEM Alarm Arm:
Diesel Glow Plug:	ORANGE / Black	Powertrain Control Module***
Clutch Bypass Wire:
Notes:	* This Is A Single Wire System. Parking Lights Need To See A Ground (-) Through A 330 Ohm Resistor. Headlights Need To See A Ground (-) Through A 700 Ohm Resistor. Diesel Vehicles - ORANGE / Black Wait to Start; Tach Wire Is Gray/Black. Both Wires Are Located In A Black Connector Center Top Of Fire Wall. There Are Two Black Connectors, The Correct One Does Not Have A White Insert. * Tach can also be located at pin 74 behind instrument cluster.

Dodge

Ram Pickup

2002-2003

Alarm and Keyless Entry Wiring Colors and Notes
Function	Vehicle Color	Location
Constant +12 Volts:	PINK/BLACK	IGNITION SWITCH HARNESS
Starter Kill:	YELLOW	IGNITION SWITCH HARNESS
Ignition +12 Volts:	BLUE (16 AWG)	IGNITION SWITCH HARNESS
Dome Lights/Superv:	SEE NOTE ***
OEM Horn:	BLACK/ RED (-)	STEERING COLUMN HARNESS
Power Lock:	WHITE/ GREEN	DRIVER'S KICK PANEL ****
Power Unlock:	WHITE/ GREEN	DRIVER'S KICK PANEL ****
Trunk Release:	N/A
Alarm Input Wire:	SEE NOTE ***
Notes:	* Separate Triggers For Each Door. The Driver's Door Trigger Is Tan (-). The Left Rear Door Trigger Is Tan/Orange (-). Both Wires Can Be Found In The Driver's Kick Panel. The Passenger Front Door Trigger Is Tan/Red (-) And the Passenger Rear Door Trigger Is Tan / YELLOW (-). Both Of These Wires Can Be Found In The Passenger Kick Panel. Diode Isolate Each Wire For Alarm Trigger With The Bands Facing Away From The Alarm/Remote Start Module. Use Only One Trigger For Dome Light Supervision. Single Wire Door Lock System See Note #211. Lock Requires A Ground (-) Pulse Through A 867 Ohm Resistor. Unlock Requires A Ground (-) Pulse Through A 364 Ohm Resistor. Diode Isolate One Of The Wires. *** Requires A Negative Pulse Through A 1.5 K-Ohm Resistor.

2005 Toyota Corolla S

1.8L VVT-i I-4

Always double check your wires with a DMM!!!

Do Not Use A Test Light!!!

MECP Certified Installer!

Best Buy 665 - IN IT TO WIN IT! TEAM MOBLE!

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Auto Starter install

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.