1995 Mazda Millenia Factory Alarm

Home / the12volt's Install Bay / Car Security and Convenience / 1995 Mazda Millenia Factory Alarm (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

elenors

Member - Posts: 1

Joined: September 12, 2004

Location: United States

Posted: November 16, 2004 at 8:16 PM / IP Logged

I am putting the security system right now. However after I pluged every wire, I did tried to remote lock and unlock.

I can lock all doors with factory secutity. But when I try to unlock the doors, Factory security (Horn) will be On.

I connected After market Alarm's lock wire with 1000ohm resister and unlock wire on one same wire( at Driver's kick panel)

How can I disarm the Factory security system when I unlock the doors?

ninjazx6e

Member - Posts: 11

Joined: November 15, 2004

Location: United States

Posted: November 16, 2004 at 9:35 PM / IP Logged

send a negative trigger to the light GREEN/ red in the drivers door harness or a positive trigger to the blue / YELLOW key sense wire in the steering column

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

1995 Mazda Millenia Factory Alarm

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.