fuel cut off wit remote start

i am wanting to add a manual fuel cut off switch in my car but I still want the remote start to work. I know that it can work with a simple  relay but I am unsure about how to hook the wires up. Basically this is what I want it to do:

1. If the remote start is used, then allow the vehicle to start regardless of position of the manual switch

2.If the key is used to start, then the manual switch will need to be set to "on" in order to allow fuel pump to get power.

i am using a prestige aps996 alarm in a 5 speed car 94 civc ...wat do i have to do to do this  thanks pm me or email me nycfinesteg@aol

Ok, your alarm should have a ground while start sire output, it is a BLACK / YELLOW in the harness located right next to the main harness.  Get a regular relay and do this:

85 - 12v Ign Fused

86 - Inline a toggle swith and ground the wire, also hook up the BLACK / YELLOW wire right before the relay.  Like this:

                                85 - _____________________    Togggle Swith    ________________                        

                                               BLACK / YELLOW hooked up to this side.

30 - one side of the fuel injection wire

87a - other side of the fuel injection wire

Hope this helps.

85 - 12v Ign Fused

86 - Inline a toggle swith and ground the wire, also hook up the BLACK / YELLOW wire right before the relay.  Like this:

                                85 - _____________________    Togggle Swith    ________________                        

                                               BLACK / YELLOW hooked up to this side.

30 - one side of the fuel injection wire

87 - other side of the fuel injection wire

Sorry about that, thanks for pinting it out.

                                85 - _____________________    Togggle Swith    ________________                        

                                               BLACK / YELLOW hooked up to this side.

SO DO I CONNECT BLACK AND YEL BEFORE THE TOGGLE SWITCH TO 85 OR AFTER

Before, so you are going to have it like this:

         85 - BLACK / YELLOW - Toggle swith

First is the relay, then the BLACK/ yell wire is connected to it, and then the toggle swith.

Let me know how it works out :)