pku-mit programming

Home / the12volt's Install Bay / Car Security and Convenience / pku-mit programming (

Topic Closed)

Welcome Guest :)

Members

Search

Register

Login

< Prev Topic Next Topic >

srusin1

Copper - Posts: 86

Joined: September 28, 2004

Posted: November 27, 2004 at 2:23 PM / IP Logged

when programming the bypass does the ground when starting wire have to be grounded. also is it ok for the power to be disconnected after programming,without doing the programming again?

Back to Top

srusin1

Copper - Posts: 86

Joined: September 28, 2004

Posted: November 27, 2004 at 5:32 PM / IP Logged

Any one have some advice because i cant get this bypass to work? What security light is supposed to go on after the pku-mit programming?

Back to Top

snguyen

Silver - Posts: 281

Joined: October 09, 2003

Location: United States

Posted: November 27, 2004 at 5:36 PM / IP Logged

No, all you need to have is the 12 volts going to it. Once you have it programmed, you can disconnect the power and not need to reprogram it.

Back to Top

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

pku-mit programming

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.