03 Monte Carlo wiring colors same as 02?

Home / the12volt's Install Bay / Car Security and Convenience / 03 Monte Carlo wiring colors same as 02? (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

Helf

Member - Posts: 16

Joined: September 03, 2003

Location: United States

Posted: January 03, 2005 at 8:49 AM / IP Logged

I will be doing a remote start today on a 03 Monte Carlo, my question is if the wiring on the 03 is the same as the 02? The newest diagram I can get my hands on is for an 02. If someone could verify this or if you have a different diagram that would be great. Thanks,

Jason

KarTuneMan

Platinum - Posts: 7,056

This member has made a donation to the12volt.com. Click here for more info.

This member consistently provides reliable information

Joined: December 14, 2004

Location: Isle Of Man

Posted: January 03, 2005 at 9:00 AM / IP Logged

12volts	red	+	ignition harness
Notes: The ignition harness is located far right of the steering column, behind the ignition switch.
Starter	yellow	+	ignition harness
Notes: The ignition harness is located far right of the steering column, behind the ignition switch.
Second Starter	N/A
Ignition	pink	+	ignition harness
Notes: The ignition harness is located far right of the steering column, behind the ignition switch.
Second Ignition	green	+	ignition harness
Notes: The ignition harness is located far right of the steering column, behind the ignition switch.
Third Ignition
Accessory	orange	+	ignition harness
Notes: The ignition harness is located far right of the steering column, behind the ignition switch.
Second Accessory	brown	+	ignition harness
Notes: The ignition harness is located far right of the steering column, behind the ignition switch. This wire must be powered as an accessory wire. If powered as an 2nd ignition the car will not crank.
Keysense
Power Lock	ORANGE / black	-	gray 24 pin plug @ BCM
Notes: Lock requires a negative trigger thru a 470 ohm resistor. Unlock requires a straight negative trigger. MUST use relays. The BCM (Body Control Module) is located above the brake pedal. It is a plastic box with three plugs that face the firewall. Can also use Directed 456A interface module.
Power Unlock	same wire as power lock
Lock Motor
Notes: Installation of factory keyless upgrade alarm is not recommended on this vehicle because the door lock motor wires rest at approximately 7 volts.
Unlock Motor
Notes: Installation of factory keyless upgrade alarm is not recommended on this vehicle because the door lock motor wires rest at approximately 7 volts.
Parking Lights+	do not use
Parking Lights-	white	-	pink 24 pin plug @ BCM
Notes: The BCM (Body Control Module) is located above the brake pedal. It is a plastic box with three plugs that face the firewall. Must isolate this wire from the BCM to avoid the service engine soon light. See DirectFax document 1600 for wiring information.
Hazards
Turn Signal(L)
Turn Signal(R)
Reverse Light
Door Trigger	blue & blue/white	-	gray 16 pin plug @ BCM
Notes: The driver door trigger wire is blue. Blue/white will catch the passenger door. Use both wires and diode isolate each. The BCM (Body Control Module) is located above the brake pedal. It is a plastic box with three plugs that face the firewall. Have to also diode isolate from the BCM to prevent false alarms. Refer to DirectFax document 1076 for wiring information.
Dome Supervision	use door trigger
Trunk/Hatch Pin	RED / black	-	gray 24 pin plug @ BCM
Notes: The BCM (Body Control Module) is located above the brake pedal. It is a plastic box with three plugs that face the firewall. Have to also diode isolate from the BCM to prevent false alarms. Refer to DirectFax document 1076 for wiring information.
Hood Pin
Trunk/Hatch Release	black	-	release switch
Power Sliding Door	N/A
Factory Alarm Arm
Factory Alarm Disarm	lt. green	-	gray 16 pin plug @ BCM
Notes: The BCM (Body Control Module) is located above the brake pedal. It is a plastic box with three plugs that face the firewall.
Disarm No Unlock	see factory alarm disarm
Tachometer	white	ac	ignition coil
Wait to start	N/A
Brake Wire	white	+	brake pedal switch
Parking Brake
Horn Trigger	black	-	steering column
Notes: Horn can also be found at a black plug with a blue insert above the gas pedal.
Memory Seat 1
Memory Seat 2
Memory Seat 3

Immobilizer Bypass Module:

Required: Yes

Type: Passlock 2

Part #: 555L or 555T

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

03 Monte Carlo wiring colors same as 02?

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.