Commando RS-HTBK2 & Acura TL

Home / the12volt's Install Bay / Car Security and Convenience / Commando RS-HTBK2 & Acura TL (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

carlmorrell

Member - Posts: 4

Joined: December 31, 2004

Posted: January 08, 2005 at 4:34 PM / IP Logged

Arrgh, what an idiot I am for attempting this myself. I just installed in a Commando EZ-2500 remote starter in a 1999 Acura TL.

It works fine as long as there is a key in the ignition. (The same key in the transponder.) I am sure I wired the bypass properly. I can hear the bypass relay click. I think the problem is I can not get the loop in the right position on the igniton lock. Any hints?

Thanks in advance, Carl

Craig3708

Copper - Posts: 155

Joined: January 30, 2004

Location: Canada

Posted: January 08, 2005 at 4:57 PM / IP Logged

If you are using the pre-fab loop-DON'T

I usually cut off the loop, strip the wire coating approx 7-8 inches and wrap it two times around the tumbler (very tight) and tape it in place. Make sure the wire is out towards the front as far as possible..

Good Luck

Craig

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Commando RS-HTBK2 & Acura TL

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.