Door Locks on 97 Mitsu Diamante

Hey guys and gals.

I'm in the process of installing a BullDog RSA112 system.  The remote start works well.  However, I am having problems with the door locks.  I could not find any wires listed in the Wiring Chart.  So I probed around and found 2 wires behind the switch.  They both go to the actuator, then they change color afterwards.  Anyways, I got the Lock to work, but the Unlock only unlocks the Driver door; not the rest.  I think the wires are ONLY to the driver door actuator.  Where are the other wires to the rest of the car???

Also, I found a pair of wires that are GND and goes +12V when lock and unlock are applied.  But applying +12V to these does nothing.

I am so lost...  If anyone installed on this car, plz lemme know what wires i need for unlock!

Thanx..

Thanks, I appreciate it.

Yep....those were the wires i used......theres no programming instructions for double pulse...just longer duration.....I contacted bulldog.  they havent responded.  anyone know if theres any wire that doesnt require double pulse?

            Hi!

             Go  to  any  car'stereo store and buy a double pulse unlock module,

            it  will  do  the  job no doubt. No  programming  is required. So,just

            hook on,that's it.

thanks....i finally got a hold of bulldog. that model does not do double pulse...so i'll just wire some relays and cap to do it...thanks again...