need help with autostart

Home / the12volt's Install Bay / Car Security and Convenience / need help with autostart (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

for fun

Member - Posts: 3

Joined: February 11, 2005

Location: United States

Posted: February 14, 2005 at 2:48 PM / IP Logged

hi everyone,

very new here but was hoping that someone can help. I have a clifford arrow3 alarm and did the remote start off the relay diagram here (10 relay total)

after all was done and doing the test. the car starts but about 2sec. later. it sounds like it is trying to start the car again and keeps doing this.

Did I do something wrong as I did follow the info. also wanted to know with the arrow3, it there a way I can control both the start and remote off?

I am using the output that was ettended for the remote trunk.

thanks alot :)

for fun

Member - Posts: 3

Joined: February 11, 2005

Location: United States

Posted: February 15, 2005 at 7:30 PM / IP Logged

anyone

boomer_106

Silver - Posts: 710

Joined: November 25, 2003

Location: United States

Posted: February 15, 2005 at 10:24 PM / IP Logged

It does say you may have to customize for the vehicle you are putting it into. You could doublecheck all your wiring. If you can afford it I think you may be better off adding an aftermarket unit. Maybe the Clifford Intellistart?

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

need help with autostart

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.