2000 Ford Explorer Diagram please

DIRECTWIRE™ WIRING INFORMATION - FORD / EXPLORER / 2000 / Remote Start 12volts yellow    +   ignition harness Starter RED / lt. blue    +   ignition harness Second Starter           Ignition GREEN/ purple    +   ignition harness Notes: Two wires each at switch, both are common, only need to power 1 each during remote start. Second Ignition           Third Ignition           Accessory gray / YELLOW    +   ignition harness Notes: Two wires each at switch, both are common, only need to power 1 each during remote start. Second Accessory BLACK/ green    +   ignition harness Keysense           Power Lock pink / YELLOW    -   driver kick panel Power Unlock pink/green    -   driver kick panel Lock Motor pink/black      driver kick panel Unlock Motor RED / orange      driver kick panel Parking Lights+ PURPLE / white      driver kick panel Notes: Also found to be WHITE/ black at the rear of the switch. Parking Lights- WHITE/ purple      driver kick panel Hazards           Turn Signal(L)           Turn Signal(R)           Reverse Light           Door Trigger      -      Notes: In the drivers door harness find yellow/black for the drivers door. In the drivers kick panel find lt. GREEN/ YELLOW for the drivers rear door. In the passengers kick panel find gray/red for the passenger front door, and pink/lt. blue for the passengers rear door. All four wires are negative trigger and must be diode isolated together. Refer to directfax document #1076 for wiring information. In the drivers door harness find yellow/black for the drivers door. In the drivers kick panel find lt. GREEN/ YELLOW for the drivers rear door. In the passengers kick panel find gray/red for the passenger front door, and pink/lt. blue for the passengers rear door. All four wires are negative trigger and must be diode isolated together. Refer to directfax document #1076 for wiring information. Dome Supervision use door trigger        Trunk/Hatch Pin WHITE/ purple    -   driver kick panel Hood Pin tan/lt.green    -   driver kick panel Trunk/Hatch Release           Power Sliding Door           Factory Alarm Arm arms on lock        Notes: Arms on lock only with door open. It is necessary to send a signal to door trigger as well as lock to arm factory alarm. Factory Alarm Disarm dk. GREEN/ purple    -   driver kick panel Disarm No Unlock           Tachometer tan / YELLOW      PCM Notes: The PCM is located at the top of the firewall towards the passenger side, the tan / YELLOW tach wire is also found at the back of the instrument cluster. Wait to start           Brake Wire lt.green    +   driver kick panel Parking Brake           Horn Trigger yellow/lt. green    -   steering column Memory Seat 1           Memory Seat 2           Memory Seat 3           Immobilizer Bypass Module: Required: Yes Type: PATS Part #: 555P, 555F, 556U, or 555U Notes: N/A        This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter. Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information. Be careful whose advice you buy, but be patient with those who supply it.