mazda millenia 1995 security system

DIRECTWIRE™ WIRING INFORMATION - MAZDA / MILLENIA / 1995 / Security 12volts BLACK/ blue or green    +   ignition harness Notes: Also found in a white plug in a silver box next to the firewall above and behind the fusebox: 12V-WHITE/ red; starter-BLACK / YELLOW 12awg; ignition-BLACK / YELLOW 18awg. Starter BLACK / YELLOW    +   ignition harness Notes: Also found in a white plug in a silver box next to the firewall above and behind the fusebox: 12V-WHITE/ red; starter-BLACK / YELLOW 12awg; ignition-BLACK / YELLOW 18awg. Ignition BLACK/ white    +   ignition harness Notes: Also found in a white plug in a silver box next to the firewall above and behind the fusebox: 12V-WHITE/ red; starter-BLACK / YELLOW 12awg; ignition-BLACK / YELLOW 18awg. Power Lock blue / YELLOW      passenger door harness Notes: Negative trigger through a 1K (1000 ohm) resistor will lock the doors and arm the factory security. Negative trigger on the same wire will unlock all doors and disarm the factory security. Test using the passengers door key cylinder switch with all doors closed. To disarm with out unlocking, send a positive trigger to the blue / YELLOW key sense wire. The key sense wire is located at the steering column. Power Unlock same wire        Lock Motor red      drivers kick panel Unlock Motor green      drivers kick panel Disarm Defeat green      passengers kick panel Parking Lights+ orange      drivers kick Notes: In a large harness to the rear of the car. Parking Lights- lt. green      steering column Hazards           Turn Signal(L)           Turn Signal(R)           Door Trigger lt. green    -   drivers kick Notes: In a large harness to the rear of the car. Dome Supervision           Trunk/Hatch Pin red    -   drivers kick Notes: In a large harness to the rear of the car. Rest at ground with the key off. Diode isolate to keep ground from feeding back from the indicator lamp. Hood Pin BROWN / white    -   top of fuse box Notes: In a 20 pin green plug. Trunk/Hatch Release BROWN / white    +   drivers kick Notes: In the harness coming in from the drivers door. Power Sliding Door           Factory Alarm Arm arms with lock        Factory Alarm Disarm disarms w/ unlock        Disarm No Unlock lt GREEN/ red    -   drivers door harness Notes: Can also use key sense wire. Tachometer yellow or grn/blu    ac diagnostic connector Notes: The diagnostic connector is in driver side rear corner of the engine compartment. Horn Trigger GREEN/ red    -   steering column Memory Seat 1           Memory Seat 2           Memory Seat 3           Interface Module: Category: Immobilizer Bypass Required: No Type: N/A Part #: N/A Notes: Interface Module: Category: Door Lock Interface Required: Yes Type: Multiplex Part #: 456LW Notes:        This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter. Directed electronics, Inc. assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information. Be careful whose advice you buy, but be patient with those who supply it.