97 cavalier diagram

hi    i got a comando alarm with remote start i want to install on my 97 cavalier. i was wondering if anybody has a wire diagram for this vehicle.thanks for the help

              haze

Constant 12 volts	RED & RED	IGNITION SWITCH HARNESS
Ignition 12 volts	PINK	IGNITION SWITCH HARNESS
Starter	YELLOW	IGNITION SWITCH HARNESS
Dome Light	L GREEN/ BLACK (DR) &	L BLUE (ALL DOORS) AT CONV. CENTER *
Trunk Pin Switch	N/A
Parking Lamp	BROWN (+)	AT HEADLIGHT SWITCH
Power Lock	L BLUE	DRIVER KICK (W/O OEM KEYLESS) **
Power Unlock	WHITE	PANEL (W/OEM KEYLESS)**

* L GREEN/ BLACK (-) Covers Driver Door Only. L BLUE (-) Covers All Other Doors. Diode Isolation Needed, Cathode (Band) Side Of Diode Faces OEM Wires. Convenience Center Module Located Above Passenger Kick Panel. ** Without OEM Keyless Door Lock Wires MUST Be Tested From PASSENGER Switch!! W/O OEM Keyless ..... Reversal Rest At Ground Door Locks. With OEM Keyless ..... Positive Pulse Door Locks

Accessories
Window Up	D\ D BLUE P\ L BLUE D\ D GREEN P\ L GREEN @ MAIN SWITCH
Window Down	F/ BROWN F/ TAN R/ PURPLE R/ PURPLE
Ign Key Warn	L GREEN (-)	IGNITION SWITCH HARNESS
Trunk Release	BLACK/ WHITE (+)	AT OEM KEYLESS MODULE *
OEM Horn	BLACK (-)	STEERING COLUMN HARNESS
Headlights	D BLUE (-) (LO) &	PINK (-) (HI) AT HEADLIGHT SWITCH
OEM Alarm Arm	N/A
OEM Alarm Disarm	N/A

Reversal Rest At Ground Power Window Circuit

. * With OEM Keyless Only!! OEM Keyless Module Located On Drivers Side Of Trunk.

Remote Start
Tach Signal	WHITE	AT POWERTRAIN CONTROL MODULE **
Ignition #2	ORANGE	IGNITION SWITCH HARNESS (HEAT/AC)
Ignition #3	WHITE	IGNITION SW. HARNESS (PCM & CLUSTER)*
Accessory	BROWN	IGNITION SWITCH HARNESS
Neutral Safety	NOT GROUNDING TYPE -	OEM SWITCH OPENS STARTER CIRCUIT
Brake Light	WHITE (+)	AT SWITCH ABOVE BRAKE PEDAL
Reverse Light	L GREEN (+)	AT SWITCH ON TRANSAXLE
Rear Window Defrost	N/A	TIMER BUILT INTO SWITCH

* 2.4L Engine Tach Wire Is WHITE At Powertrain Control Module (PCM). 2.2L Engine Tach Wire Is WHITE or ORANGE At PCM Or Ignition Control Module. Both Wires Are 2 Cylinder Signals Each. PCM On Both Located In Passenger Front Fender. Ignition Control Module On 2.2L Located On Rear Center Of Engine. ** WHITE Wire Powers Powertrain Control Module (PCM) & Instrument Cluster. 

G.M. Passlock Diagram.

MO

Don't Learn from Others Mistakes

You Might Be the One That Knows.

thanx mo your a blessing from god.  i was starting to pull my hair out by the roots.  with this diagram i'll be able to do my task at hand.   again thanx and god blessthanks for the help

              haze