page guard 8500s alarm

i got my alarm installed the other day and i noticed the the trunk is not hooked up its a power trunk id like to know what needs to be donte to hook this up or where i can look,  also my camera on my alarm will not take any pictures its a page guard 8500s im pritty sure its in the programming of it but my instructions are not very good any sugestions

What kind of car???Keith

there should be two wires coming off the back of the trunk release button. One should be BLACK/ white, a negative trigger to this wire will do the trick. Make sure you test it before you go hooking wires up. Life moves pretty fast; if you don't stop and look around once in a while; you could miss it.

im trying to wire up my power locks to the alarm but when i wire up the relays the way supose to it dose not work ive got the heave duty 12volt relays from canadian tire and i also got no power locks on my car but i purchesed some to work with the alarm its a pageguard alarm and the door locks came from a salvage yard they do work i tested them with the battery and the work any sugsetions

http://caralarm.net/eng/img/mnu/pg-8500s.pdf thats the diagram ive been following theres only 2 wires coming from the door lock modual a grey one and a brown one

Can't get that LINK to work..........

You will need 2 SPDT ( Single Pole Double Throw ) Relays

2 SPDT RELAYS:

NO SWITCH

Lock & Unlock from Alarm ONLY

Relay 1

LOCK:

PIN 87 =  12 Volts ( + ) ConstantPIN 87a = GROUNDPIN 30 =  wire to Positive side of ActuatorsPIN 85 = Negative Lock Output from AlarmPIN 86 = Constant 12 volt ( + )

Relay 2

UNLOCK:

PIN 87 =  12 Volts ( + ) ConstantPIN 87a = GROUNDPIN 30 =  wire to Positive side of ActuatorsPIN 85 = Negative UnLock Output from AlarmPIN 86 = Constant 12 volt ( + )

MO

Don't Learn from Others Mistakes

You Might Be the One That Knows.

mo12v wrote: Can't get that LINK to work.......... You will need 2 SPDT ( Single Pole Double Throw ) Relays 2 SPDT RELAYS: NO SWITCH Lock & Unlock from Alarm ONLY Relay 1 LOCK: PIN 87 =  12 Volts ( + ) Constant PIN 87a = GROUND PIN 30 =  wire to Positive side of Actuators PIN 85 = Negative Lock Output from Alarm PIN 86 = Constant 12 volt ( + ) Relay 2 UNLOCK: PIN 87 =  12 Volts ( + ) Constant PIN 87a = GROUND PIN 30 =  wire to Positive side of Actuators PIN 85 = Negative UnLock Output from Alarm PIN 86 = Constant 12 volt ( + )

ok now what about the rest of my wires from the alarm copy and past the link it should work that way

What is your Question??Are you needing ALL the wire hook up for your Alarm?MO

Don't Learn from Others Mistakes

You Might Be the One That Knows.