Viper 330V problems?

I installed the above alarm in a friends van last evening & I can't seem to get it working. As soon as I apply power to it the blue led lights up. Tried programming & seem to get the right flashes to acknowledge it's correct, yet the light won't go out. Tried to exit programming mode But the light still stays on. Any ideas? Thanks

your in valet mode. get out of it

Do you mean hold the key in the on position for at least 15 seconds? If not how do I get out of valet mode? Thanks

Tried the open door key in ignition, wait for 15 seconds, turn off. Light still comes on. Idea's?

Checking with my 707T wiring, I may have the blue in H2/4 connected instead of red H2/3. Would the led stay on if that was the case? Thanks

3 botton remote open door hit locl/unlock then aux then lock/unlock 4 button     open door hit lock then unlock then lock again from key turn igon on then back off hit valet button once all this doen in less then 15 secs

I't only a two button remote. Lock-unlock. Would the alrm refuse to program if the RED -disarm defeat input wan not wired? if so could this be my problem not being able to finish the programming? Thanks

As of this afternoon I rewired the alarm. The existing one in it was an audiovox & I used some of the wiring. Not now. I know all wiring is correct. Programs fine. Panic alarm works if you hit the lock remote button twice. It does not arm. I tried jumping the green H2/2 to 12volts & nothing. Siren works. Pouched? Have I missed something? Here is what is connected: Main Harness H1/2-light flash output H1/5-(-) door trigger H1/8-ground H1/10-(+) siren output H1/11-(+) 12V constant input Auxillary Harness H2/2-arm input H2/3-red disarm defeat input. That's it.