doorlocks on 06 dodge charger

does anyone kno if i need relays for the doorlocks for this car?

Only if your rs unit doesn't have them built in.. need resistors though....Tire Proz Stillwater Mn

High End Restyling and Comlete Repair

Here is what DEI lists for the Charger DIRECTWIRE™ WIRING INFORMATION - DODGE / CHARGER / 2006 / Remote Start [PRINT THIS PAGE] 12volts      lt. blue/red (15A)       +       ignition harness Starter      pink/dk. green       +       ignition harness Second Starter      PURPLE / brown       -       ignition harness Notes: The second starter wire is negative trigger thru an 180 ohm resistor. MUST use a relay. Refer to DirectFax document 1084 for wiring information. Ignition      pink/white       +       ignition harness Second Ignition                  Third Ignition                  Accessory      same as second starter wire       -       ignition harness Notes: The accessory wire is negative trigger thru a 610 ohm resistor. MUST use a relay. Refer to DirectFax document 1084 for wiring information. Second Accessory                  Keysense                  Power Lock      PURPLE / dk. green       -       DKP or cluster, gry 26P plug, pin 5 Notes: Lock is negative trigger thru a 330 ohm resistor. Unlock is negative trigger thru a 100 ohm resistor. MUST use relays. Power Unlock      same as power lock wire             Lock Motor      lt. green       5wi      DKP or cluster, gry 26P plug, pin 12 Unlock Motor      tan/lt. green       5wi      DKP or cluster, gry 26P plug, pin 11 Parking Lights+      WHITE/ purple       +       pass. kick, brn 26 pin plug, pin 26 Parking Lights-      WHITE/ brown       -       sw or cluster, gry 26P plug, pin 3 Notes: Parking lights are negative trigger thru an 1,670 ohm resistor. There is a rest resistance on the wire, so must use a relay to isolate from the switch. Hazards      WHITE/ dk. blue       -       hazard switch Turn Signal(L)      use hazards wire             Turn Signal(R)      use hazards wire             Reverse Light      WHITE/ lt. green       +       pass. kick, brn 26 pin plug, pin 17 Door Trigger      see notes       -       each kick or instrument cluster Notes: The LF door is purple in the white plug, pin 3. The RF door is PURPLE / white in the white plug, pin 16. The LR door is PURPLE / gray in the gray 26 pin plug, pin 10. The RR door is purple / YELLOW in the gray 26 pin plug, pin 9. Use all four wires and diode isolate each. Dome Supervision      yellow/white       +       instrument cluster, wht plug, pin 12 Notes: Also found in the passenger side A pillar. Trunk/Hatch Pin      PURPLE / orange       -       PKP or cluster, gry 26P plug, pin 23 Hood Pin      PURPLE / lt. blue (export only)       -       pin switch under hood Trunk/Hatch Release      PURPLE / tan       -       sw or cluster, gry 26P plug, pin 22 Notes: The trunk release motor wire is tan / YELLOW (5wi) in the passenger kick or instrument cluster, white plug, pin 24. Power Sliding Door      N/A             Factory Alarm Arm      arms on lock with door open             Factory Alarm Disarm      factory remote only             Disarm No Unlock      with ignition and Sentry Key             Tachometer      NOT BROWN / yellow       ac       any ignition coil or fuel injector Wait to start      N/A             Brake Wire      dk. GREEN / WHITE       +       brake pedal switch Parking Brake      gray/black       -       sw or cluster, gry 26P plug, pin 18 Horn Trigger      dk. GREEN/ orange       +       horns under hood Memory Seat 1      PURPLE / brown       -       memory switch in driver door Notes: Memory seats are negative trigger thru resistors. The resistor values are not known at this time. Cut the wire and meter the values as you press the memory 1 and memory 2 buttons. Memory Seat 2      same as memory seat 1 wire       -       Memory Seat 3      N/A       -       Interface Module:      Category: Immobilizer Bypass      Required: Yes      Type: Sentry Key Part #: 556CW Alternate Part1 #: DesignTech 29402 Alternate Part2 #: 556UW Alternate Part3 #: DesignTech 20402 Notes: Standard on all models. Interface Module:      Category: Door Lock Interface      Required: No      Type: Multiplex Part #: 456LW Notes: Interface Module:      Category: Combo Interface      Required: No      Type: Data Bus Part #: IOM-Chrysler-7 Notes: Smart Starter Kill Relays:      Relay Type: Starter Relay      Location: Engine compartment fusebox, Driver side Part #: 6401A warning       This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter. Directed Electronics assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information. This car has a unique second starter/accessory wire that requires a little more than a normal vehicle (although becoming standard on chrysler). I would recommend picking up this, this piece does door locks, Trunk release, horn honk, and arm/disarm of factory alarm.