1997 Honda Prelude Factory Keyless

Does anyone know where the factory keyless module is located?  i think mine got unhooked or something when the people that had it before me put a alarm on it... they took the alarm off of it before i bought it and now the keyless doesnt work... any help would be appreciated.. its a 1997 honda prelude s model..."Vtec Keep Left, Slow Traffic Keep Right"

DIRECTWIRE™ WIRING INFORMATION - HONDA / PRELUDE / 1997 / Keyless Entry 12volts white    +   ignition harness Starter BLACK/ white    +   ignition harness Ignition BLACK / YELLOW    +   ignition harness Power Lock BLACK/ white    -      Notes: located in the passengers kick at the multiplex control unit in a blue 14 pin connector. May also be in a gray 2 pin connector taped to another harness with blue tape above the driver kick panel. Power Unlock blue/orange    -      Notes: located in the passengers kick at the multiplex control unit in a blue 14 pin connector. May also be in a gray 2 pin connector taped to another harness with blue tape above the driver kick panel. Lock Motor WHITE/ red      bottom of fuse box Unlock Motor lt.GREEN/ red      bottom of fuse box Parking Lights+ RED / black        Notes: located in a white plug just behind the cruise control switch. Parking Lights-           Hazards           Turn Signal(L)           Turn Signal(R)           Door Trigger WHITE/ black    -   bottom of fuse box Dome Supervision comes on with unlock        Trunk/Hatch Release           Power Sliding Door           Factory Alarm Arm           Factory Alarm Disarm           Disarm No Unlock blue    -   in drivers door Horn Trigger blu/rd or lt grn/blu    -   steering column Memory Seat 1           Memory Seat 2           Memory Seat 3           Interface Module: Category: Immobilizer Bypass Required: Yes Type: Transponder Part #: 555DW Alternate Part1 #: 556UW Alternate Part2 #: DesignTech 20402 Alternate Part3 #: DesignTech 29402 Notes: Smart Starter Kill Relays: Not Available        This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter. Directed Electronics assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information. Be careful whose advice you buy, but be patient with those who supply it.

so are you saying that its the multiplex unit? cause i dont see anything about the FACTORY keyless module???"Vtec Keep Left, Slow Traffic Keep Right"

It's "built in " to the fuse box. UP HIGH you'll find the plug you need with the lock wires in it. The plug is grey.