2000 Bonneville, 555G problem

Hi I installed a BOA 165B with 555GW into a 2000 Bonneville (Passkey III). I tried starting it before the 555G and it worked fine with the key in the ON position. Another weird thing it's doing, it keeps on flashing the lights even after the vehicle is on. So the problem is, I can't find the Immobilizer ignition wire (White or Pink) the one I'm supposed to cut and connect the Pink/Black to the key side and the Pink to the ECM side. Also in the install it says to get to the Purple data wire at the ignition, again it's not there and I had to go to the OBD connector Pin2. Jumper is set to data but when I press the button on R/S the 555G LED flashes even after the car is started??? I've found 2-white and 1-pink wire at the ignition switch and tried them all but no luck still flashing. Any help???

isn't a 2000 bonneville VATS, 555g is for passkey3 does the key have a resistor pellet in it? if so you have the wrong bypassShaughn Murley

Install Manager, Dealer Services

Visions Electronics

Red Deer, Alberta

No, the key got a PK3 on it. I'm having trouble finding them.

Is it normal that during programing of the 555G that it flashes every sec? Or should the LED stay lit until the car is started/programmed?