autopage rs860lcd on a xb

im installing a autopage 860 on my 06 scion xb and i was wondering about the pink wire in the 20 pin harrness that controles the 2 step unlock.  How do i wire it in and also how do i wire the door locks?  Thanks Rich

DIRECTWIRE™ WIRING INFORMATION - SCION / XB / 2006 / Keyless Entry [PRINT THIS PAGE] 12volts      wht/blue (40A), wht/red (15A)       +       ignition harness Starter      black       +       ignition harness Ignition      black       +       ignition harness Power Lock      blue/white       -       driver kick, 14 pin plug Notes: Meter this wire while turning the key in the driver door key cylinder. Power Unlock      yellow/black (double pulse)       -       driver kick, 14 pin plug Notes: Meter this wire while turning the key in the driver door key cylinder. Can also use the passenger door key cylinder wire for unlock, which only requires a single pulse. It is blue/red (-) in the passenger kick in a 14 pin plug. Lock Motor      blue/orange       5wi      driver kick, 9 pin plug Unlock Motor      YELLOW /GREEN       5wi      driver kick, 9 pin plug Parking Lights+      green       +       headlight switch Notes: Also found at the top of the fuse box in a 13 pin plug. Parking Lights-      N/A             Hazards      GREEN/ orange       -       hazard switch Turn Signal(L)      GREEN/ black       +       top of fuse box, 13 pin plug Turn Signal(R)      GREEN/ YELLOW       +       top of fuse box, 13 pin plug Door Trigger      RED / white       -       top of fuse box, 9 pin plug Dome Supervision      use door trigger wire             Trunk/Hatch Release      BROWN / yellow       -       driver kick, harness to rear Notes: Meter this wire while opening the hatch from the handle on the rear hatch. The hatch release motor wire is blue / YELLOW (+) in the driver kick, harness to rear. Power Sliding Door      N/A             Factory Alarm Arm      N/A             Factory Alarm Disarm      N/A             Disarm No Unlock      N/A             Horn Trigger      WHITE/ red       -       horn switch Memory Seat 1      N/A             Memory Seat 2      N/A             Memory Seat 3      N/A             Interface Module:      Category: Immobilizer Bypass      Required: No      Type: N/A Part #: N/A Notes: Smart Starter Kill Relays: Not Available warning       This wiring information is being provided free of charge on an "as is" basis, without any representation or warranty. It is your responsibility to verify any circuit before interfacing with it using a digital multimeter. Directed Electronics assumes no responsibility with regards to the accuracy or currency of this information. Proper installation in every case is and remains the responsibility of the installer. DEI assumes no liability or responsibility resulting from improper installation, even in reliance upon this information. Wire a 5-wire setup to the unlock of the drivers door motor using the system's normal/first unlock wire as a trigger. Then use the standard unlock output to the power unlock in the passenger kick panel as listed above.