Valet 562T, 02 Avalanche

Does anyone out there have the specifics for wiring a Valet 562T in a 2002 Avalanche? I'm wanting to hook up everything, including the defroster, and coming up emply handed for a complete list of the wire colors/locations for all the wires on this remote start. Also would like to know of any relays or diodes I will need, as I want to keep the factory unlock the same, where one push of the unlock only unlocks the drivers door, and two presses of the button unlock all of them.  I received the remote start as a gift with a bypass for passkey II. All the sites I've found are either incomplete (bulldog is close, but missing some of the wires I need), or I can only get the vehicle specific chart if I bought my unit from their company. Can anyone end my frustrations?

Trigger the rear defrost at the defogger switch....white wire, it's a NEG(-) pulse.

thank you!

do I need a relay or diode to trigger this wire, or just tap a direct connection?

you can directly tap the wire in the car with the valet defrost wire.

Thank you Mobile Customs. I'm looking forward to getting this installed this weekend, it's getting cold up here in Indiana. Now if I can just figure out how to hook up my heated drivers seat.....

check out bypasskit.com they may have a module that does everything you need heat seats, defrost etc.

Ok, one final question, page 12 of my installation manual says to refer to techtip 1041 for wiring information on the door lock harness (H4), but I can find nothing regarding this technical bulletin. am I crazy? I want to hook it up like my factory keyless, press unlock once, it unlocks the drivers door, press it again, it unlocks the rest. do I need diodes to prevent backfeed? What wires hook to what in my Avalanche?