01 ford ranger remote start

I have an 01 ford ranger, I am trying to find a wire diagram to install a prostart CT - 3200   can anyone out there help me out ?

12volts      yellow        +       ignition harness Starter      RED / lt. blue        +       ignition harness               Ignition      lt. GREEN/ purple        +       ignition harness                    Accessory      gray / YELLOW        +       ignition harness Second Accessory      BLACK/ lt. green        +       ignition harness                  Power Lock      pink / YELLOW        -       driver door harness or PKP Power Unlock      pink/lt. green        -       driver door harness or PKP Notes: The GEM in this vehicle shuts down after the doors have been locked for a certain time period, to wake-up the system refer to directfax document #1093. Lock Motor      pink/black              driver door harness Unlock Motor      RED / orange              driver door harness Parking Lights+      brown              headlight switch or GEM Notes: The GEM (Generic Electronic Module) is to the left of the radio.                     Door Trigger              -       GEM Notes: The driver door trigger is yellow/black and the passenger door(s) is gray/red. Use both wires and diode isolate as shown in directfax document #1076. The GEM (Generic Electronic Module) is to the left of the radio. Dome Supervision      use door trigger                                                 Tachometer      tan / YELLOW              instrument cluster or PCM Notes: The PCM (Powertrain Control Module) is on the top of the firewall under the hood towards the passenger side. The tachometer wire is in pin 48. Can also get tach at the ignition coil or coil pack. Use any of the tan/stripe wires.                    Brake Wire      lt. green        +       brake pedal switch                    Horn Trigger      yellow/lt. green        -       steering column Immobilizer Bypass Required: Yes       Type: SecuriLock Part #: 1100F Alternate Part1 #: 1100X Alternate Part2 #: 556SW Alternate Part3 #: 556UW Alternate Part4 #: DesignTech 20402 Alternate Part5 #: DesignTech 29402 Notes: When using the 1100X, a software change to 1100FM is needed.

on the back of the remote starter unit 12 digit number go prostart.org then go to downloads type in that number its a 1 time only so print off what u need .dragon