2007 chrysler aspen remote start

Does anyone has a wiring diagram for this truck? I used CHDL7-PK2, it worked fine except when you shut the remote start down, the truck stays running! Help please.

Do you have access to directechs.com? I recently asked for a wiring diagram of that truck there and a wiring diagram from Astroflex was posted. Here are the basics: Battery   RED / gray Ignition Pink/Gray Starter PURPLE / brown thru 200 ohm resistor to ground Accessory same purple brown thru a 590 ohm resistor to ground Brake WHITE/ tan Parking lights (+) pink/red drivers kick panel Parking lights (-) pink/red 1.1k ohms Lock lt. blue/orange 330 ohms in door UnLock lt. blue/orange 100 ohms in door I helped another installer do an Aspen last week, so I'm pretty familar with the truck. We used 2 relays for the PURPLE / brown MUX wire and a PKU-CH2 for the key bypass.

its very similar to the new rams that dont have the starter wire. You can see my post on the 07 Ram with the mux wiring. Wire it up like that with the appropriate resistor values for the ASPEN and you should be fine. Done a couple aswell, and sounds like JWorm is quite familiar also. So with that combo, should be able to get ya going.Shaun, we are the same height, that is neat!

12V Installation Technician for Honda, Dodge, Chrysler, Toyota and Jeep.