94 saab 9000 remote start problem

Home / the12volt's Install Bay / Car Security and Convenience / 94 saab 9000 remote start problem (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

gotpiranha

Member - Posts: 10

Joined: June 25, 2006

Location: United States

Posted: March 06, 2007 at 12:52 PM / IP Logged

I have the new viper 5900 alarm and remote starter.After I find the tach wire.I did the tach learning with the car running and pressing the valet button until the led stay solid.But after that I tried to start with the remote and the car would only crank nonstop and the car doesnt start at all.Any suggestion

Twelvoltz

Platinum - Posts: 2,384

This member has made a donation to the12volt.com. Click here for more info.

This member consistently provides reliable information

Joined: March 24, 2005

Location: New Jersey, United States

Posted: March 06, 2007 at 1:12 PM / IP Logged

Just to make sure you have all of your other connections correct, set the unit to voltage sensing and set your crank time to 1 second. If the vehicle starts and runs you know the problem is with that tach connection and you will need to find another. If it does not start and run your problem is elsewhere.

Installer, IT support, and FFL. I need less hobbies.

gotpiranha

Member - Posts: 10

Joined: June 25, 2006

Location: United States

Posted: March 06, 2007 at 9:00 PM / IP Logged

How do I go back and set it to sense the voltage?

Twelvoltz

Platinum - Posts: 2,384

Joined: March 24, 2005

Location: New Jersey, United States

Posted: March 06, 2007 at 9:36 PM / IP Logged

Keep in mind I only recommend this for troubleshooting. A tachometer connection is the best way to go for that vehicle. Take a look at your installation manual in the programming charts. Options 3-2, 3-5, and 3-6.

Installer, IT support, and FFL. I need less hobbies.

gotpiranha

Member - Posts: 10

Joined: June 25, 2006

Location: United States

Posted: March 07, 2007 at 12:50 AM / IP Logged

Okay Thanks for the info.Also is there a way I can reset the whole alarm /remote starter back to the factory default setting and start all over?

gotpiranha

Member - Posts: 10

Joined: June 25, 2006

Location: United States

Posted: March 09, 2007 at 12:41 PM / IP Logged

Okay I tried the voltage and it did start acouple time and somtime it doesnt.So I dont know what the problem is now.So I set it back to tach sense and tried the tach learning again and the led never came on.What am I doing wrong here?

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

94 saab 9000 remote start problem

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.