03 mazda speed protege

Hey guys, I have done all of the research I could, but have different sources telling me different things so I have a few questions. 1. Is there any wiring differences between a standard Protege and the Speed? 2. Is a transponder bypass required for this vehicle, if so can you recommend a good no key required model? 3. Lock and Unlock are the same wire? Need 1k resistor through neg trigger to activate? 4. I am installing a new compustar pro series and have not yet installed one, though I have done many of the standard ones, but anyone know of any major differences I should prepare for? Thanks in advance

Remote Start                WIRE          COLOR          POLARITY          LOCATION           Battery          BLACK          (+)          IGNITION SWITCH HARNESS           Ignition 1          BLUE          (+)          IGNITION SWITCH HARNESS           Ignition 2          BLACK/ RED          (+)          IGNITION SWITCH HARNESS           Accessory 1          BLACK/ WHITE          (+)          IGNITION SWITCH HARNESS           Starter 1          BLACK/ BLUE          (+)          IGNITION SWITCH HARNESS           Key Sense          WHITE          (+)          IGNITION SWITCH HARNESS           Neutral Safety          BLACK/ BLUE          (-)          AT MODULE UNDER CENTER CONSOLE - PIN #25           Tachometer          VIOLET/WHITE          (AC)          AT DIAGNOSTIC CONNECTOR      DIAGNOSTIC CONNECTOR IS LOCATED IN THE DRIVER'S SIDE REAR OF ENGINE COMPARTMENT           Speed Sense          GREEN/ RED          (AC)          IN HARNESS BEHIND INSTUMENT CLUSTER           Parking Lights          LIGHT GREEN/ BLACK          (+)          AT BLACK CONNECTOR NEAR STEERING COLUMN           Brake Lights          GREEN/ YELLOW          (+)          AT SWITCH ABOVE BRAKE PEDAL           Reverse Lights          RED / YELLOW          (+)          IN DRIVER'S KICK PANEL           Horn          BLACK/ RED          (-)          IN STEERING COLUMN HARNESS      Doorlocks           WIRE          COLOR          POLARITY          LOCATION           Power Unlock          LIGHT GREEN/ RED          (-)          AT MODULE TO THE LEFT OF THE BRAKE      STRAIGHT GROUND WILL UNLOCK THE DOORS           PowerLock          LIGHT GREEN/ RED          (-)          AT MODULE TO THE LEFT OF THE BRAKE      GROUND THROUGH A 1K OHM RESISTOR TO LOCK All Door Trigger          BLACK/ BLUE          (-)          IN DRIVER'S KICK PANEL           Trunk Trigger          BLUE          (-)          AT LIGHT IN TRUNK OR HARNESS GOING INTO TRUNK           Parking Lights          LIGHT GREEN/ BLACK          (+)          AT BLACK CONNECTOR NEAR STEERING COLUMNHouston,TX

"The two most common elements in the universe are H+ and stupidity" (Ellison).

Thanks, but is there a bypass module required?

No transponder bypass is required on an 03 Mazda Protege, the speed is the same car with a better drive train.Installer, IT support, and FFL. I need less hobbies.