the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
icon

alarm in a 2003 xterra


Post ReplyPost New Topic
< Prev Topic Next Topic >
Prophit 
Copper - Posts: 79
Copper spacespace
Joined: March 04, 2004
Location: United States
Posted: May 19, 2007 at 5:20 PM / IP Logged  

Im installing an ASIANWOLF FM 2009 in a 2003 nissan xterra. I have a factory alarm installed currently. I Just wanted to know if there where any special instructions for this install? I did find the instructions from this site,

NISSAN / XTERRA / 2003 / Remote Start
12voltsgreenignition harness
Starter BLACK / YELLOWignition harness
Second Starter GREEN/ YELLOWignition harness
IgnitionBLACK/ whiteignition harness
Second Ignition          
Third Ignition          
AccessoryRED / yellow ignition harness
Second Accessory WHITE/ blue ignition harness
Notes: NOT required for remote start.
Keysense          
Power Lock yellow   -   SECU
Notes: Meter these wires while turning the key in either door key cylinder.
The SECU (Smart Entrance Control Unit) is to the right of the steering column.
Power Unlock yellow/redSECU
Notes: Meter these wires while turning the key in either door key cylinder. Unlock requires a double pulse.
The SECU (Smart Entrance Control Unit) is to the right of the steering column.
Lock Motor blue  blue 5wi SECU
Notes: The SECU (Smart Entrance Control Unit) is to the right of the steering column.
Unlock Motor GREEN / WHITE 5wiSECU
Notes: The SECU (Smart Entrance Control Unit) is to the right of the steering column.
Parking Lightsblue/red steering column
Parking Lights-          
Hazards          
Turn Signal(L)          
Turn Signal(R)          
Reverse Light          
Door Trigger     -     
Vehicles with power door locks use GREEN/ red for the driver door, GREEN/ black for the front passenger door, and RED / black for the rear doors. All found at the SECU, use all three wires and diode isolate each.
The SECU (Smart Entrance Control Unit) is to the right of the steering column.
Dome Supervision          
Trunk/Hatch Pin          
Hood PinBLACK/ pinkSECU
Notes: The SECU (Smart Entrance Control Unit) is to the right of the steering column.
Trunk/Hatch Release          
Power Sliding Door N/A       
Factory Alarm Arm arms with lock       
Factory Alarm Disarm disarms with unlock       
Disarm No Unlock single pulse on unlock wire       
Tachometer pink/blue or blackinstrument cluster or ECM
Notes: The ECM (Engine Control Module) is located below the heater box to the right of the accelerator pedal, behind trim panel. The tach is in the top row, 3rd pin left of center of the plug.
Wait to start N/A       
Brake WireBROWN / redbrake pedal switch
Parking Brake          
Horn Trigger ltGREEN/ red or brown steering column

Im doing this install on monday and wanted to get everything ready and setup before hand. Thanks for the help

mikvot 
Gold - Posts: 1,043
Gold spaceThis member has made a donation to the12volt.com. Click here for more info.spacespace
Joined: December 19, 2006
Location: Missouri, United States
Posted: May 19, 2007 at 7:12 PM / IP Logged  

Nope, nothing special if its just an alarm..............slaaaammmerrrrr

12volts
Starter
Second Starter
Ignition
Second Ignition
Third Ignition
Accessory
Second Accessory
Keysense
Power Lock
Power Unlock
Lock Motor
Unlock Motor
Parking Lights+
Parking Lights-
Hazards
Turn Signal(L)
Turn Signal(R)
Reverse Light
Door Trigger
Dome Supervision
Trunk/Hatch Pin
Hood Pin
Trunk/Hatch Release
Power Sliding Door
Factory Alarm Arm
Factory Alarm Disarm
Disarm No Unlock
Tachometer
Wait to start
Brake Wire
Parking Brake
Horn Trigger

NISSAN, XTERRA, 2003, Door Trigger
On vehicles without power door locks use RED / black at any door pin switch or also found in the driver A pillar. Vehicles with power door locks use GREEN/ red for the driver door, GREEN/ black for the front passenger door, and RED / black for the rear doors. All found at the SECU, use all three wires and diode isolate each.
The SECU (Smart Entrance Control Unit) is to the right of the steering column.
Prophit 
Copper - Posts: 79
Copper spacespace
Joined: March 04, 2004
Location: United States
Posted: May 22, 2007 at 4:29 PM / IP Logged  

Thank alot for those directions. Im a little rusty. Im having problems with the door locks. Could someone show me a diagram that would work for my application. I believe i have a 2 zone reversed polarity. But i could be wrong. Am i going to need relays? I have a couple i believe to be 5wi modules. Could i use those? I have almost the rest done. Just need to figure out window modules. I will post about that later. Thanks. I have pictures of instructions for my alarm if needed.


Sorry, you can NOT post a reply.
This topic is closed.

  Printable version Printable version Post ReplyPost New Topic
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

  •  
Search the12volt.com
Follow the12volt.com Follow the12volt.com on Facebook
Wednesday, May 15, 2024 • Copyright © 1999-2024 the12volt.com, All Rights Reserved Privacy Policy & Use of Cookies
Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

Secured by Sectigo
the12volt.com spacer
the12volt.com spacer
the12volt.com spacer
Support the12volt.com
Top
the12volt.com spacer
the12volt.com spacer