Power Door Lock Issue, 2003 Nissan Xterra

hello all,

I was wondering if someone could shed some light on how to do the power door locks wiring for my truck. I tried this mornign and failed. Now my door locks dont work at all. Please help

2003 Xterra, alarm is a fm 2009 from asian wolf. Green is lock output (-) and Blue is unlock output (-).

Thanks for all the help!!

You blew a fuse, bro.

Check all your lower dash fuses and ALL your engine fuses.  You tagged the wrong wire when attempting to attach the blue/green wires from the alarm to the nissan.  You then grounded a 12 volt carrying wire and blew a fuse -- i would hope that you didn't also fry a transistor in the asian wolf.

when i hit the switch on either doors i hear the relay but nothing moves. Same with the keyless entry and new alarm. any suggestions?

Check all your lower dash fuses and ALL your engine fuses

disconnect the blue and green wires (off the alarm) to whichever nissan wires you connected them to.  Their connection may continuously be grounding the 12 volts that the power locking system is sending to the doorlock motor/actuator. 

I couldn't find a copy of the xterra service manual online (for free) so I can't go through the electrical wiring diagram (EWD) .. otherwise it'd be fairly straightforward to see which fuses are connected to the keyless entry/doorlocking system. re-check your fuses if the problem persists, you may have overlooked one -- are you just visually inspecting them or actually testing them?

no problem -- if you can link me to the EWD, I can help you figure out what's going on .  You can go to tradebit.com and purchase the service manual for $20, or you can go to nissan's tech website and pay $20 and get a 24hr pass that'll give you access to the EWD/repair manual.

btw -- which wires specifically DID you have the GREEN/ blue wires connected to?