viper 5000, ’89 s10 blazer

Hey every one im new to this forum and im running around in circles trying to figure this out,,,,, i have a viper 5000 alarm system and im trying to make it pop my back window on my 89 s-10 blazer.  Im using the red and white wire like is says in the install book but where im stuck is the red and white wire sends out a ground signal so when i hook it up to the relay like you normally would it doesnt do crap all?  Any help would be great... thx josh

well right after i made this post i saw the part on how to change the polarity on a realy, and as soon as i did that it worked liked a charm, so thans for the help

So i was lookin on here and saw how to wire up the starter kill with a realy and it seemed really simple, but then when i grabbed my install guide for my alarm it showed a different way of doing it (i think).

I used the basic starter kill on this site ( norm closed) as my guide.  So before i start cuttin and joining stuff, i wanted a bit of verification as to what i should do.....    Thx