p2w9000fmr no signal after dead battery

Home / the12volt's Install Bay / Car Security and Convenience / p2w9000fmr no signal after dead battery (

Topic Closed)

Welcome Guest :)

Members

< Prev Topic Next Topic >

garrettbowman

Member - Posts: 2

Joined: February 06, 2007

Location: Canada

Posted: September 24, 2007 at 1:01 PM / IP Logged

Hello,

I have a p2w9000fmr compustar alarm/start combo in my 2003 trailblazer ltz and everything worked fin for over 6 months. I then had a dead battery which was stone dead, i boosted the truck, my alarm chirped for a second and after that my remote couldnt get a signal from the alarm.

I received a new brain under warranty as compustar had said the low voltage damaged the unit. I just installed the brain and I still have no signal. Is it possible the antenna was damaged by the boost?

garrettbowman

Member - Posts: 2

Joined: February 06, 2007

Location: Canada

Posted: September 24, 2007 at 1:21 PM / IP Logged

Sorry guys, I just programmed to remote and everything is good again.

Sorry, you can NOT post a reply.
This topic is closed.

Printable version

You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot delete your posts in this forum
You cannot edit your posts in this forum
You cannot create polls in this forum
You cannot vote in polls in this forum

Search the12volt.com

Follow the12volt.com

Disclaimer: *All information on this site ( the12volt.com ) is provided "as is" without any warranty of any kind, either expressed or implied, including but not limited to fitness for a particular use. Any user assumes the entire risk as to the accuracy and use of this information. Please verify all wire colors and diagrams before applying any information.

p2w9000fmr no signal after dead battery

Sorry, you can NOT post a reply.This topic is closed.

Sorry, you can NOT post a reply.
This topic is closed.