04 pontiac aztek

using a 5ooors scytek alarm the vehicle shows three ignition circuits but the alarm remote start only has two. does the third need to be hooked up? and if so can i just use a relay and run from the second ignition output and connect it to ign.2 and 3 together?In case of snow drive backwards, instant front wheel drive, then again who needs it when you drive a Scoobie

You can run a relay to the other ignition you need to power up by hooking up a negative output off remote start that is a 2nd ignition out put. Battery             MUST RUN WIRE TO BATTERY           Ignition 1     PINK             (+)     IGNITION SWITCH HARNESS           Ignition 2     DARK GREEN     (+)     IGNITION SWITCH HARNESS           Accessory 1     BROWN (must be powered)     (+)     IGNITION SWITCH HARNESS           Accessory 2     ORANGE          (+)     IGNITION SWITCH HARNESS           Starter 1     YELLOW          (+)     IGNITION SWITCH HARNESS pin 85 to 12v+ fused pin 86 to (-) 2nd ignition pin 30 to 12v+ fused pin 87 to 2nd ignition wire in vehicle You may have to find a second accessory as well unless the 2nd accessory is only to power radio and wiper circuit.The wire I'm test'n isn't doin' what it's supposed to be doin'... I am so glad I printed that tech sheet, with the wrong info.

Do it right the first time... or I might have to fix it for ya

thanks guys will reply when i hook it up this weekend.In case of snow drive backwards, instant front wheel drive, then again who needs it when you drive a Scoobie